Splitting Table Knife for Wolfcraft Master Cut 2500 by Wolfcraft — max. 160 mm blade compatible

Replacement splitting table knife designed for the Wolfcraft Master Cut 2500. This accessory is intended for use with circular saw blades up to 160 mm and helps maintain safe material separation behind the blade to reduce binding and kickback. The component supports accurate cutting lines on the Master Cut 2500 table saw setup and contributes to improved operator safety during ripping and crosscutting operations.

Advantages

The splitting table knife reduces lateral pressure on the workpiece and prevents the kerf from closing behind the blade, lowering the risk of pinching and kickback. It is manufactured to match the geometry required by the Master Cut 2500 system and provides consistent alignment with blades up to 160 mm. The part is compact and straightforward to install, making replacement or upgrade quick during workshop maintenance.

Suitable for

• Table saw setups using the Wolfcraft Master Cut 2500 system
• Cuts with circular saw blades up to 160 mm diameter
• Ripping long boards and panels
• Crosscutting small workpieces where kerf stability is required

Key specifications

• Compatible blade diameter: up to 160 mm
• Function: splitting/anti-kickback knife for table saw kerf control
• Fitment: designed for integration with the Master Cut 2500 table system
• Form factor: slim, table-mounted knife suitable for through-cut applications

How to use

Install the splitting table knife into the mounting slot provided by the Master Cut 2500 table according to the system's assembly instructions. Position the knife so it stands just behind the saw blade at the same height as the blade's plate to maintain kerf separation. After installation, verify blade-to-knife alignment with a test cut on scrap material and make fine adjustments if necessary. Regularly check that the knife is secure and undamaged before use.

Usage recommendations

Use the splitting table knife only with compatible circular saw blades up to 160 mm and only on the Wolfcraft Master Cut 2500 table system. Always disconnect power to the saw before installing, adjusting, or inspecting the knife. Replace the knife if it becomes bent, cracked, or shows excessive wear to maintain safe kerf control and consistent cut quality.