YATO pipe reamer and calibrator for PEX-AL-PEX pipes 16×20×26 mm YT-22374

YATO pipe reamer and calibrator for PEX-AL-PEX pipes 16×20×26 mm YT-22374 is a hand tool designed to prepare multilayer PEX-AL-PEX pipe ends for reliable joining. The tool removes internal and external burrs, creates a smooth chamfer and restores consistent outer and inner diameters for pipes with nominal sizes 16 mm, 20 mm and 26 mm. It is intended for use during plumbing, heating and general installation work to ensure proper fit of compression fittings, press fittings and other connection systems that require precise pipe geometry.

Advantages

The tool combines reaming and calibration functions in a single compact device, reducing the need for multiple tools. Its design enables quick removal of burrs and accurate chamfering while maintaining concentricity and consistent diameter across the pipe end. The handheld format provides simple manual control and immediate preparation on-site without power supply. Constructed for workshop and field use, the instrument supports repeatable finishing for multilayer PEX-AL-PEX pipes.

Suitable for

• Plumbing installation and repair work with multilayer pipes
• Heating system assembly and maintenance using PEX-AL-PEX tubing
• Preparation of pipe ends for compression, press or crimp fittings
• On-site trimming and finishing of pipe ends before jointing

Key specifications

• Compatible pipe outer diameters: nominal 16 mm, 20 mm, 26 mm
• Function: reaming (deburring), chamfering and calibration
• Hand-operated: manual control without power source
• Suitable for multilayer PEX-AL-PEX pipes
• Portable, compact design for field and workshop use

How to use

Measure and mark the required cut length, then cut the PEX-AL-PEX pipe squarely with an appropriate cutter. Insert the pipe end into the reamer and calibrator until it seats, and rotate the tool by hand to remove burrs and form a uniform chamfer. Continue rotating while checking the fit of the pipe onto the fitting; repeat the process until the pipe slides on smoothly and the end face is even. After calibration, inspect the pipe end visually for burrs, and if necessary perform a final light pass to ensure concentricity and correct diameter.

Usage recommendations

Use the tool on clean, dry pipe ends and avoid excessive force during reaming to prevent over-sizing. Verify compatibility with the specific fitting system in use and perform trial fits on scrap pieces when using new pipe or fittings to confirm correct preparation. Keep the working edges clean and store the tool dry to maintain performance.