Hole saw YATO YT-3313 — single, Ø 3.2 cm, for drill; aluminium, cast iron, plastic, stainless steel, wood

YATO YT-3313 is a single hole saw with a 3.2 cm diameter designed for use with standard drills. It cuts round openings in a range of materials including aluminium, cast iron, plastic, stainless steel and wood, providing a compact and straightforward tool for installation and repair tasks. The cutter is intended for applications where a small circular aperture is required, offering compatibility with common drill chucks and straightforward handling for single-hole operations.

Advantages

The hole saw delivers precise circular cuts with a consistent 3.2 cm diameter suitable for pipe entries, cable pass-throughs and similar penetrations. Its construction allows cutting across soft and hard materials—metal and non-metal—without the need to change tool types frequently. The design is compact for easy storage and transport, while compatibility with standard drills makes it convenient to use on site or in a workshop.

Suitable for

• Creating pipe and conduit openings for plumbing and HVAC
• Making cable and wire passage holes for electrical installations
• Cutting small vent or access holes in furniture and panels
• General repair and maintenance requiring round holes in mixed materials

Key specifications

• Cutting diameter: 32 mm
• Type: single hole saw for drill
• Compatible materials: aluminium, cast iron, plastic, stainless steel, wood
• Designed for use with standard drill chucks

How to use

Secure the hole saw in the drill chuck according to the drill manufacturer’s instructions. Mark the center of the intended hole on the workpiece and, if possible, use a pilot bit or center punch to prevent walking. Start drilling at low speed to establish the cut, then increase speed and apply steady, even pressure. For metal materials, use cutting fluid or lubricant and moderate speed to reduce heat buildup; for wood and plastic, higher speed and light pressure typically produce cleaner cuts. Withdraw the saw periodically to remove debris and allow cooling. After cutting, deburr the hole edges as required.

Usage recommendations

Use appropriate personal protective equipment (safety glasses, gloves) and secure the workpiece before drilling. Match drill speed and lubrication to the material being cut: lower speeds and cutting fluid for stainless steel and cast iron, higher speeds for wood and softer plastics. Inspect the hole saw for wear before use and replace if teeth are damaged to ensure safe and accurate cutting.