The Yato YT-3327 hole saw with a 5.7 cm diameter is a single-cutting tool designed for creating clean round holes in a range of common workshop and site materials. Built for through-holes in aluminium, cast iron, plastics, stainless steel and wood, this hole saw is intended to provide precise sizing and efficient material removal where a consistent circular opening is required.
Advantages
This hole saw offers a compact diameter for detailed or small-diameter applications while maintaining compatibility with a variety of materials. Its cutting geometry is optimized to balance speed and accuracy, reducing the need for secondary finishing of the hole edge. The tool’s construction supports repeated use in mixed-material jobs, and its size simplifies alignment and control when used with standard drilling equipment.
Suitable for
- Cutting round holes in aluminium sheets and profiles
- Boring through cast iron components for repair or fitting tasks
- Making openings in plastic panels and housings
- Drilling circular access or pass-through holes in stainless steel
- Creating precise openings in timber and wood panels
Key specifications
- Diameter: 5.7 cm
- Type: single hole saw (single-tooth cutting design)
- Compatible materials: aluminium, cast iron, plastic, stainless steel, wood
- Intended use: through-hole cutting for installation, repair and fabrication
- Fitment: designed for use with standard drill arbors/chucks (ensure correct arbor size)
How to use
Fit the hole saw to a suitable drill arbor or mandrel that matches your drill’s chuck size and secure it firmly. Mark the centre of the hole on the workpiece and, if available, use a pilot bit or pilot guide to stabilize the cut. Start drilling at low speed to establish the cutting path, then increase speed as appropriate for the material while applying steady, even pressure. For metals, use cutting fluid to reduce heat and extend tool life. After cutting, remove any burrs or sharp edges with a file or deburring tool.
Usage recommendations
Use appropriate personal protective equipment (safety glasses, gloves, hearing protection) and clamp the workpiece to prevent movement. Match drill speed and feed rate to the material being cut: slower speeds for stainless steel and cast iron, moderate speeds for aluminium and plastics, and higher speeds for softwood. Periodically withdraw the hole saw to clear chips and avoid clogging, and apply cutting lubricant when drilling metals to improve finish and prolong tool life.
