Hole saw YATO YT-43970, single, for drill, diameter 1.6 cm, suitable for ceramic concrete plastic wood

Single hole saw YATO YT-43970 is a compact cutting accessory designed for use with a standard drill. With a cutting diameter of 1.6 cm, this hole saw is intended to create clean circular openings in ceramic tiles, concrete, plastic and wood. Its single-piece construction and compact size make it suitable for precision work during installations, repairs and DIY tasks where a small, accurate hole is required.

Advantages

The YATO YT-43970 offers a small-diameter solution for accurate drilling with minimal chipping on fragile surfaces such as ceramic. Its design provides compatibility with common drill chucks, allowing quick attachment and operation with ordinary drills. The tool is versatile across multiple materials—ceramic, concrete, plastic and wood—reducing the need to change accessories for different tasks. Its compact diameter supports precision positioning in tight spaces and on finished surfaces.

Suitable for

• Cutting small-diameter holes in ceramic tiles for fittings and fixtures
• Creating openings in concrete for anchors and cable passages
• Drilling through plastic panels and housings for cable routing
• Making precise holes in wood for dowels, pipes or decorative elements

Key specifications

• Cutting diameter: 1.6 cm
• Compatibility: fits standard drill chucks
• Material applicability: ceramic, concrete, plastic, wood
• Design: single-piece hole saw for small-diameter holes
• Intended use: installation, repair, and DIY precision cutting

How to use

Securely fit the YATO YT-43970 into the drill chuck according to the drill manufacturer’s instructions. Mark the centre of the required hole on the workpiece and position the hole saw tip at that point. Start drilling at low speed to establish the cutting line, then increase speed as appropriate for the material while maintaining steady pressure. For ceramic and fragile surfaces, use light pressure and consider backing the tile to reduce chipping. For concrete, use intermittent drilling and allow the tool to cool to avoid overheating. Remove debris periodically to maintain cutting efficiency.

Usage recommendations

Wear appropriate personal protective equipment such as safety glasses and gloves. Use suitable drill speeds for each material: lower speeds and gentle pressure for ceramic, higher torque at moderate speeds for concrete and wood. When drilling plastics, use steady feed to avoid melting. Keep the hole saw clean from dust and debris and inspect it regularly for wear; replace if teeth are damaged or cutting performance degrades.