Angle grinder accessory YATO YT-47880 — disc ø15 cm, 1 pc

YATO YT-47880 is a replacement accessory for angle grinders: a single polishing pad with a 15 cm (150 mm) diameter supplied as one piece. This polishing pad is designed to fit grinders with an M14 threaded arbor and provides a soft sponge surface suitable for finishing and light polishing tasks. It is intended as a consumable part for routine maintenance and small repair jobs where a 150 mm polishing surface is required.

Advantages

The soft sponge construction offers gentle contact with work surfaces, reducing the risk of surface damage while delivering even finishing results. The M14 thread ensures compatibility with a wide range of common angle grinders, and the pad’s 150 mm diameter provides a balance between working area and maneuverability. Rated for use up to 5000 RPM, the pad is suitable for typical polishing speeds and can be replaced quickly when worn.

Suitable for

• Polishing and finishing of painted or lacquered surfaces
• Light buffing of metal, plastic or composite materials
• Small restoration and maintenance tasks on machinery and vehicles
• Surface preparation before applying sealants or coatings

Key specifications

• Disc diameter: 150 mm
• Pad thickness: approximately 50 mm (sponge height)
• Material: soft sponge polishing pad
• Thread type: M14 (for attachment to compatible angle grinders)
• Maximum recommended speed: 5000 RPM
• Quantity per pack: 1 piece

How to use

Attach the polishing pad to an angle grinder equipped with an M14 threaded arbor, ensuring the tool is powered off and disconnected from the power source. Secure the pad by threading it onto the arbor until it is firmly seated. Operate the grinder at speeds not exceeding the pad’s maximum recommended RPM and apply light, uniform pressure while moving across the work surface to avoid overheating or excessive wear. After use, inspect the pad for wear and replace when the sponge or contact surface shows significant degradation.

Usage recommendations

Use compatible polishing compounds or pads appropriate for the specific material being worked on, and wear suitable personal protective equipment (eye protection, gloves, and a dust mask) when polishing to protect against debris and dust. Avoid operating at speeds above 5000 RPM and store the pad in a dry place to prolong service life.