Cutting disc YATO YT-6013 for angle grinder — Ø 125 mm, for ceramic, glass, tile, porcelain, stone

The YATO YT-6013 cutting disc for angle grinders is a thin 125 mm abrasive wheel designed for cutting ceramic, glass, glazed tile, porcelain and natural or engineered stone. Its slim profile supports precise straight cuts and neat trimming work, making it suitable for tasks where controlled, low-chip cutting is required. The disc fits standard 125 mm grinder flanges and is intended for use with handheld angle grinders in renovation and installation projects.

Advantages

The thin abrasive construction reduces material loss and produces narrower kerf widths for more accurate cuts. The disc is engineered to deliver clean edges on brittle materials such as ceramic and glass, minimizing chipping and breakage when used with appropriate cutting technique. Compatibility with common 125 mm angle grinders and flanges simplifies replacement and job-site use. The design balances cutting speed and control to support both fine trimming and longer straight cuts.

Suitable for

• Cutting ceramic and glazed tiles during tiling and bathroom or kitchen renovation
• Trimming porcelain tiles and porcelain stoneware for a precise fit
• Cutting glass panels and small glass components
• Shaping and trimming natural or engineered stone for decorative work
• On-site adjustments and straight cuts with handheld angle grinders

Key specifications

• Disc diameter: 125 mm
• Intended materials: ceramic, glazed tile, porcelain, glass, stone
• Disc profile: thin/low kerf for precise cuts
• Tool compatibility: standard 125 mm angle grinders
• Typical application: manual cutting and trimming with handheld grinders

How to use

Mount the disc on a compatible 125 mm angle grinder following the tool manufacturer's instructions and ensure the flange and arbor are clean and correctly tightened. Use appropriate personal protective equipment — safety glasses, gloves, hearing protection and a dust mask. For best results, mark the cut line and perform steady, controlled passes without forcing the disc; allow the abrasive to do the cutting. For brittle materials like ceramic and glass, support the workpiece close to the cut and maintain consistent feed speed to reduce chipping. Allow the disc to cool periodically during extended cutting to avoid overheating.

Usage recommendations

Use the disc on materials listed and avoid cutting ferrous metals. Maintain correct rotational direction and recommended speed ranges for 125 mm discs as stated by your angle grinder; do not exceed the maximum RPM rating printed on the grinder or accessory. Replace the disc if it shows cracks, uneven wear, or other damage before use.