Clamp YATO YT-6413, length 400 mm, 1 piece

The YATO YT-6413 clamp is a 400 mm length clamping tool supplied as a single piece, designed to hold, secure and align workpieces during assembly, gluing or woodworking operations. With a conventional clamp form factor and a 400 mm throat, it is intended for applications that require moderate reach and steady pressure to keep parts in position while adhesives set or fasteners are fitted.

Advantages

This clamp provides stable holding force with a straightforward mechanism that is easy to operate by hand. Its 400 mm reach accommodates a variety of panels, frames and components without excessive bulk. The single-piece supply simplifies inventory and selection for both hobbyists and professionals who need a reliable tool for repeatable positioning and temporary fixing.

Suitable for

• Woodworking and carpentry assemblies
• Gluing and adhesive bonding tasks
• Light metalworking and sheet alignment
• Hobby and DIY projects requiring moderate clamping reach
• Workshop holding during drilling, fastening or finishing

Key specifications

• Overall length: 400 mm
• Supply: single piece
• Form factor: standard manual clamp
• Intended use: holding, securing and aligning workpieces
• Typical applications: assembly, gluing, woodworking

How to use

Position the clamp so that the fixed jaw contacts one side of the workpiece and the movable jaw aligns with the opposite side. Adjust the movable jaw along the bar to the required opening, then operate the clamping mechanism until the workpieces are held firmly but without over-tightening. Verify alignment and pressure distribution before leaving glued joints to cure or before proceeding with drilling or fastening operations. Release the clamp by reversing the mechanism and slide the jaws apart to remove the workpiece.

Usage recommendations

Use protective pads where necessary to avoid marring finished surfaces, and avoid applying excessive torque to prevent distortion of thin materials. Inspect the clamp regularly for wear or damage and replace if any part shows deformations that could affect clamping accuracy.