Yato YT-84944 power chainsaw accessory 1 pc(s)

Yato YT-84944 power chainsaw accessory is a single steel cutting chain compatible with many petrol and electric chainsaws. Designed with a 20" length, 76 links, 0.325" pitch and 0.058" (1.5 mm) gauge, the chain uses a pó³³-type cutting tooth made from Mn65 manganese steel to provide higher breaking strength and extended service life. The product is intended for cutting clean and moderately dirty wood and is specially recommended for use with the YATO guide YT-84937 and saw YT-84900.

Advantages

The Yato YT-84944 chain integrates an even lubrication system that distributes oil along the entire bar to reduce friction and limit bar heating, which helps prolong the life of the cutting system. Its cutting-tooth geometry gives high cutting speed while the material choice increases resistance to wear and breakage. The design reduces vibration by approximately 25%, improving operator comfort during prolonged use. Guide links are optimized to reduce kickback risk, increasing safety when cutting.

Suitable for

• Cutting clean wood and moderately dirty wood for domestic and light professional tasks
• Replacement chain for petrol and electric chainsaws compatible with 20" bars and 0.325" pitch
• Use with YATO guide YT-84937 and YATO saw models such as YT-84900
• General forestry maintenance, pruning, and firewood preparation

Key specifications

• Material: Mn65 manganese steel
• Length: 20" (approx. 51 cm)
• Number of links: 76
• Pitch: 0.325"
• Gauge (cutting width): 0.058" (1.5 mm)
• Cutting tooth type: pó³³-type for high cutting speed
• Lubrication system: even oil distribution along the bar
• Vibration reduction: special tooth design reduces transferred vibration by ~25%
• Kickback reduction: optimized guide links to lower recoil risk

How to use

Fit the Yato YT-84944 chain to a compatible 20" guide bar following the chainsaw manufacturer’s instructions. Ensure correct orientation and tension the chain to the recommended specification before each use. Check and top up bar lubrication, and inspect the chain for damage or excessive wear. When installing, wear appropriate protective gloves and follow safe handling procedures. After installation, run the saw at idle to verify oil feed and chain seating, then perform a short test cut to confirm correct function.

Usage recommendations

Use the chain for clean or moderately dirty wood; avoid prolonged cutting in heavily contaminated or abrasive materials. Maintain correct chain tension and adequate bar lubrication during operation. Sharpen or replace the chain when cutting performance degrades or if links show damage. For compatible performance, pair with YATO guide YT-84937 and recommended YATO chainsaw models.