Patch cable ACT CAT6A U/FTP LSZH Slimline 0.15 m with RJ45 90° right to straight, black

ACT Cat6A U/FTP LSZH Slimline patch cable, 0.15 m, combines a reduced outer diameter and U/FTP shielding for reliable short‑run 10GbE connections in confined spaces. The cable uses full‑copper 32AWG conductors and 50 µin gold‑plated RJ45 contacts and is fitted with a straight RJ45 on one end and a 90° right‑angled RJ45 on the other. The LSZH jacket lowers the risk of toxic gas emission if the cable is exposed to fire or severe damage.

Advantages

The slimline design (approximately 3.8 mm outer diameter) reduces cable bulk and improves airflow in racks and cabinets while maintaining the required bend radius for Cat6A performance. U/FTP shielding minimises crosstalk and helps preserve signal integrity on short high‑speed links. Gold‑plated contacts and full copper conductors ensure consistent electrical contact and compliance with international standards; each cable is 100% tested.

Suitable for

• Short patch runs in server racks and network cabinets
• Connections behind equipment where space is limited
• Patch panels and dense cabling environments requiring improved airflow
• 10 Gigabit Ethernet links over short distances

When it may not be suitable

This 0.15 m slimline patch cable is designed for very short connections; it is not appropriate for longer horizontal or backbone runs where longer lengths and different cable categories or constructions are required. In environments where maximum mechanical robustness is necessary (for example exposed runs with frequent physical stress), a thicker jacket or different cable type may be preferred.

Key specifications

• Cable category: Cat6A U/FTP (shielded twisted pair)
• Length: 0.15 m
• Conductor: solid full copper, 32 AWG
• Connectors: RJ45 straight — RJ45 90° angled right
• Contacts: 50 µin gold‑plated
• Jacket: LSZH (Low Smoke Zero Halogen)
• Outer diameter: approximately 3.8 mm (slimline)
• Colour: Black
• Tested: 100% tested for conformity

How to use

Insert the straight RJ45 plug into the corresponding port on a switch, patch panel or device and route the 90° angled plug to the equipment or patch panel port where space behind the device is constrained. Avoid sharp bends beyond the cable's bend radius and secure the cable to maintain airflow and strain relief. The short 0.15 m length is intended for direct patching between adjacent ports.

What to consider before purchase

• Required cable length — 0.15 m is for very short adjacent connections
• Compatibility with equipment ports and orientation (straight vs angled connector)
• Need for LSZH jacket in your installation environment and fire‑safety requirements
• Whether a slimline 3.8 mm diameter cable meets your durability needs

Usage recommendations

Use this ACT Cat6A U/FTP LSZH Slimline 0.15 m patch cable for short, high‑density rack or patch panel connections where reduced diameter and a right‑angled plug improve cable routing and airflow. Avoid using it for longer runs or in applications requiring extra mechanical protection.