ACT S/FTP CAT6A B2ca PoE++ 100W prefab installation cable, 90 m, RJ45 male–female (FB0190)

The ACT S/FTP CAT6A B2ca PoE++ 100W prefab installation cable (FB0190) is a 90 m pre-terminated solid installation cable engineered for 10 Gigabit Ethernet and high-power PoE deployments. Constructed as S/FTP with full copper 23AWG conductors and screened foil shielding, the cable reduces electromagnetic interference and maintains signal integrity across long runs. Factory-fitted RJ45 male-to-female connectors use IDC termination and 50 µin gold-plated contacts to provide a durable, low-loss connection without field termination.

Advantages

The pre-terminated design removes the need for on-site assembly or special tools, enabling consistent, repeatable connections and reducing installation time and human error. Compliance with ANSI/TIA-568.2-D and ISO/IEC 11801-1 standards and CPR Euroclass B2ca rating ensures suitability for demanding installations. Support for 4PPoE / PoE++ up to 100 W allows powering of modern high-consumption devices over the same cable used for data.

Suitable for

• Structured cabling in data centers and server rooms
• Power over Ethernet installations delivering up to 100 W (4PPoE / PoE++)
• Commercial and public buildings requiring high fire performance (Euroclass B2ca)
• HDBaseT video distribution and 10 Gigabit Ethernet links
• Quick deployments where plug-and-play pre-terminated cables reduce installation time

When it may not be suitable

This solid pre-terminated cable is designed for fixed installations and may not be the best choice where frequent reconfiguration, extreme flexing, or continuous movement is expected; stranded patch cords are better suited to such conditions. It is also intended for in-wall or structured cabling runs rather than direct exposure to outdoor environmental conditions unless additional protection is applied.

Key specifications

• Cable type: S/FTP CAT6A solid
• Length: 90 m
• Conductors: full copper, 23 AWG
• Connectors: pre-terminated RJ45 male to RJ45 female with IDC termination
• Contacts: 50 µin gold-plated
• Shielding: screened foil around individually shielded pairs with overall screen
• Data rate: suitable for 10 Gigabit Ethernet
• PoE support: 4-pair PoE / PoE++ up to 100 W
• Standards: ANSI/TIA-568.2-D, ISO/IEC 11801-1
• Fire performance: CPR Euroclass B2ca
• Colour: Blue

How to use

Plan the cable route and measure run lengths to ensure the 90 m reach suits the installation. Route the prefab cable through conduits or cable trays as required and secure with appropriate cable management. Plug the pre-terminated RJ45 male end into the network device or patch panel and connect the RJ45 female end to the existing in-wall outlet or extension patch cord as needed. No termination tools are required; verify continuity and Ethernet link speed after installation and ensure cable bends do not exceed recommended bend radii.

What to consider before purchase

• Verify run length requirements to ensure 90 m is sufficient for your topology
• Confirm that a solid installation cable (not stranded) is appropriate for the intended environment
• Check PoE power requirements of connected devices to ensure 100 W support meets needs
• Confirm that Euroclass B2ca fire rating is required or preferred for your building codes
• Ensure compatibility with existing connectors and patching equipment

Usage recommendations

Use the pre-terminated ACT S/FTP CAT6A cable for permanent structured cabling runs in ceilings, walls, and cable trays where high bandwidth, interference protection, and up to 100 W PoE power are required. Avoid tight bends, protect against physical damage, and pair with compliant patch panels and equipment to maintain performance and safety.