LED Strip Connector ACT FOC-SCSC-9SMD-5 for SMD LED strips, 9-pin inline splice, 5 mm pitch

ACT FOC-SCSC-9SMD-5 is a 9-pin inline connector engineered for SMD LED strips with a 5 mm pitch. The connector enables a compact splice between two strip segments without soldering, preserving correct pin alignment and signal continuity for multi-channel LED tapes. It is designed for quick inline repairs or extensions of addressable or RGBW-like SMD LED tape runs used in signage, backlighting and other flexible lighting installations.

Advantages

The connector offers a tool-free splicing method that reduces installation time and eliminates the need for soldering. Its inline 9-pin design ensures reliable electrical contact across all channels while keeping the connection compact and low-profile. The housing secures the strip edges to maintain correct alignment and minimize signal errors, and the product is compatible with standard 5 mm pitch SMD LED tapes, allowing straightforward integration into existing lighting assemblies.

Suitable for

• Joining or repairing 9-conductor SMD LED strips with 5 mm pitch
• Quick inline connections for signage and channel letters
• Backlighting installations behind displays and panels
• Flexible LED runs in architectural accents and cove lighting
• Temporary or prototype LED installations where solderless connections are preferred

Key specifications

• Pin count: 9 pins for multi-channel LED strips
• Pitch compatibility: 5 mm SMD LED strip pitch
• Connection type: inline splice for solderless joining
• Contact method: mechanical clamp contacts ensuring continuity across channels
• Form factor: low-profile inline housing suitable for tight installations

How to use

Prepare the SMD LED strip ends by cutting precisely on the designated cut lines and ensuring the copper pads are clean and correctly exposed. Open the connector housing, insert each strip end so that the pads align with the corresponding contacts and the tape sits flat within the guide, then close and secure the housing until it locks. Verify that the alignment is correct across all nine contacts and power the strip at low brightness to confirm signal continuity before finalizing the installation.

Usage recommendations

Use the connector only with compatible 5 mm pitch SMD LED strips and ensure correct orientation of the conductor pads to avoid channel miswiring. For permanent outdoor or moisture-prone installations, add appropriate weatherproofing around the splice. Avoid excessive bending or strain at the splice point and check contact integrity after long-term operation.