The Afriso ball valve with actuator BEV 2-way DN25 is a compact valve assembly intended for on/off control of liquid and gaseous media in HVAC and industrial installations. The two-way ball design with a DN25 connection size allows straightforward integration into piping systems where automated flow shutoff or switching is required. The valve accepts a motorized or pneumatic actuator mounting interface to enable remote operation and integration with control systems.
Advantages
This two-way ball valve offers a simple, robust shut-off mechanism with low flow resistance when fully open. The compact construction and standard DN25 connection facilitate retrofit and new installations. Compatibility with common actuator mounting patterns allows flexible automation options and straightforward replacement of manual valves. The design is suitable for frequent on/off cycles and supports reliable tight shut-off for liquid and gaseous media.
Suitable for
- HVAC systems for controlling heating and cooling circuits
- Industrial piping where automated on/off control is required
- Process systems handling water, glycol mixtures, compressed air or other non-corrosive gases
- Retrofitting manual ball valves to automated actuator control
When it may not be suitable
The valve is designed primarily for on/off applications; it is not intended for precise proportional flow control or throttling where accurate modulation is required. Media that are highly abrasive, corrosive, or contain large particulate matter may reduce service life unless appropriate material compatibility and filtration are ensured.
Key specifications
- Valve type: two-way ball valve
- Nominal diameter: DN25
- Operation: actuator-mounted (motorized or pneumatic interface)
- Suitable media: liquid and gaseous media (non-corrosive; e.g., water, glycol, compressed air)
- Function: on/off shut-off
- Typical application area: HVAC and industrial installations
How to use
Install the valve in the piping with correct flow orientation and ensure secure mechanical connections to DN25 pipework. Mount a compatible actuator to the valve's actuator interface according to the actuator manufacturer's instructions, aligning drive spindles and securing coupling hardware. Connect control and power lines to the actuator and commission the assembly by performing open/close cycles, checking for proper travel, tight shut-off, and absence of leaks. Follow applicable safety procedures when working with pressurized systems and energized control equipment.
What to consider before purchase
- Confirm DN25 connection size matches existing piping and fittings
- Verify material compatibility with the intended media and operating temperature range
- Ensure actuator type (motorized or pneumatic) and mounting pattern are compatible with the valve interface
- Check required pressure rating and sealing performance for the application
Usage recommendations
For reliable operation, install appropriate upstream filtration to prevent particulate ingress, follow actuator manufacturer torque and mounting guidelines, and perform periodic leak and cycle testing as part of routine maintenance.
