Fiber optic transceiver module ALLNET ALL4760

The ALLNET ALL4760 is an SFP+ fiber optic transceiver module designed for 10 Gbit/s network links. Operating at a wavelength of 1310 nm, this module supports high-speed data transmission over extended distances while maintaining signal integrity. Its metallic enclosure provides mechanical durability and electromagnetic shielding suitable for installation in compatible SFP+ ports on switches, routers and optical equipment.

Advantages

The module provides a stable 10000 Mbit/s data rate over fiber connections and a standardized SFP+ interface for broad compatibility with network hardware that accepts SFP+ optics. With a 1310 nm operating wavelength, the transceiver is suitable for single-mode fiber runs where longer reach is required. The metallic finish contributes to physical robustness and heat dissipation, and the device is designed to operate within typical low-voltage system environments.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Long-distance single-mode fiber links using 1310 nm optics
• Data center and enterprise network aggregation ports supporting SFP+
• Replacement or expansion of existing SFP+ fiber transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1310 nm
• Housing: metallic enclosure
• Maximum operating voltage: 3.6 V

How to use

Install the ALLNET ALL4760 into an available SFP+ slot on a compatible network device with the optical port oriented according to the device manual. Connect the appropriate single-mode fiber cable with matching connectors to the transceiver, ensuring correct polarity. After physical installation, verify link status and speed through the host device management interface and confirm that the module is recognized and operating at 10 Gbit/s. Follow the host equipment vendor’s guidance for hot-plug handling and ESD precautions when inserting or removing the transceiver.

Usage recommendations

Use single-mode fiber rated for 1310 nm to achieve the specified reach, verify compatibility with the target SFP+ port before deployment, and follow standard electrostatic discharge precautions when handling the module. For optimal performance, check device firmware and interface settings on the host equipment to ensure the transceiver operates at the intended 10 Gbit/s link rate.