Ethernet-to-2-Wire Converter Set Atte 33101 with Power and Data Conversion

The Atte Ethernet-to-2-Wire Converter Set 33101 provides a solution for transmitting Ethernet network signals over existing two-wire cabling and restoring them back to standard Ethernet at the remote end. The kit enables data communication between network devices where running new twisted-pair or fiber cabling is impractical. Designed for integration into industrial and building network layouts, this converter set supports extending network reach using a simple two-conductor medium while maintaining Ethernet connectivity between devices.

Advantages

This converter set allows reuse of existing two‑wire infrastructure to carry Ethernet traffic, reducing the need for new cable installation. It offers a compact, easy-to-deploy solution for extending network connectivity to remote equipment. The design focuses on reliable data link conversion with straightforward wiring and minimal site modification, making it suitable for retrofit projects and constrained installation environments.

Suitable for

• Connecting Ethernet devices over legacy two‑wire cabling in buildings
• Extending network reach to remote equipment without installing new Ethernet cable
• Industrial automation and control panels where only two‑conductor runs are available
• Temporary or permanent installations that require simple network extension

Key specifications

• Function: Ethernet signal conversion to two‑wire medium and reconversion to Ethernet
• Medium supported: two‑conductor cable for data transport
• Intended use: point‑to‑point link between two converter units
• Power: includes power conversion capability to supply remote unit (local power requirements at each end may apply)
• Form factor: compact modules suitable for equipment racks or junction enclosures
• Application environment: building and industrial network installations

How to use

Install one converter unit at the network source and the paired unit at the remote device location. Connect the Ethernet port on the source-side unit to the network switch or device using standard Ethernet cable. Run the existing two‑wire cable between the two converter units and connect the two conductors to the designated terminals on each module. Provide power according to the product’s power input requirements so that the set can perform both data conversion and power conversion for the remote side if supported. After connections and power are applied, verify link and data transmission between Ethernet devices and adjust network settings as needed.

Usage recommendations

For reliable operation, use sound two‑wire cabling in good condition and observe the maximum recommended run length specified by the manufacturer. Place converters in dry, ventilated locations and ensure proper grounding of associated network equipment. When deploying in industrial environments, consider interference sources and route two‑wire runs away from heavy power lines where possible.