Patchcord UTP 8 conductor RJ45 to RJ45 15 m BLOW 2748

UTP patchcord with eight conductors and RJ45 male connectors at both ends, 15 meters long, model BLOW 2748. Designed for Ethernet network connections, cable patching and device linking in LAN environments, this pre-terminated cable provides a flexible solution for horizontal or inter-rack connections where a 15 m reach is required. The cable is suitable for connecting switches, routers, patch panels and workstations and supports standard UTP cabling practices for reliable data transmission in office and server-room installations.

Advantages

This BLOW UTP patchcord delivers a ready-to-use connection without the need for on-site termination, reducing installation time and minimizing signal loss associated with poor crimps. The 15 m length offers extended reach for mid-distance runs while remaining flexible enough for clean routing in cable management systems. Factory-terminated RJ45 connectors ensure consistent contact quality and predictable electrical characteristics when used with standard Ethernet equipment.

Suitable for

• Connecting switches to patch panels in wiring closets and racks
• Linking routers, network appliances and desktop workstations
• Horizontal cabling runs up to 15 m in offices and commercial spaces
• Temporary or permanent patching in server rooms and network cabinets

Key specifications

• Cable type: Unshielded Twisted Pair (UTP)
• Number of conductors: 8 (4 pairs)
• Connector type: RJ45 male — both ends
• Length: 15 meters
• Intended use: Ethernet LAN patching and device interconnection
• Typical applications: Horizontal and patch-cord connections for 10/100/1000Base-T networks

How to use

Route the patchcord between the two network ports you intend to connect and insert the RJ45 plugs fully into the respective RJ45 sockets until the latch clicks. Avoid tight bends near the connectors and keep the cable away from strong electromagnetic sources to reduce interference. If used in a rack or cabinet, secure the cable with appropriate cable management accessories to prevent strain on the connectors and preserve performance over time.

Usage recommendations

For optimal performance, use this UTP patchcord within standard Ethernet environments and pair it with properly terminated patch panels and switches. Avoid running the cable in parallel with high-voltage power lines, and do not exceed the intended 15 m length for horizontal runs where signal integrity matters. Inspect connectors periodically for secure seating and replace the cable if the jacket or connectors show physical damage.