BlueOptics InfiniBand/fibre optic cable 10 m 2x LC LC/APC Yellow

The BlueOptics InfiniBand/fibre optic cable 10 m 2x LC LC/APC Yellow is a 10 metre single-mode patch cable designed for high-speed optical links. It uses G.657.A1 laser-optimized single-mode fiber with a 9 µm core diameter and two LC connectors in APC polish, supporting full-duplex InfiniBand and other optical connectivity applications. The cable features an LSZH (low-smoke, zero-halogen) outer jacket for safer deployment in enclosed spaces and is intended for connecting patch panels, transceivers and other fiber equipment where reliable, low-loss transmission is required.

Advantages

This fibre optic cable provides low attenuation and high return-loss performance typical for G.657.A1 single-mode fibers, ensuring stable signal transmission over its 10 m length. The use of precision ceramic ferrules and industry-grade connectors supports high mating-cycle durability and consistent optical contact. LSZH sheathing reduces smoke and halogen emission in the event of fire and simplifies installation in data centre and indoor environments. The cable is tested with interferometry and OTDR to verify input loss and return loss values.

Suitable for

• InfiniBand high-speed interconnects and low-latency clusters
• Patch panel to patch panel connections in data centres
• Connecting optical transceivers and SFP/ QSFP modules
• Indoor backbone and horizontal fiber runs where LSZH jacket is required

Key specifications

• Length: 10 metres
• Fiber type: Single-mode G.657.A1 (laser-optimized)
• Core diameter: 9 µm
• Connector configuration: LC to LC, APC polish
• Duplex: Full duplex (2 fibers)
• Sheath: LSZH (low-smoke, zero-halogen)
• Tested parameters: Input loss and return loss measured; OTDR and interferometer tested
• Compliance: Manufactured to common industry standards for fiber performance and safety

How to use

Install the cable by routing it through the cable management system to avoid tight bends; observe the minimum bend radius specified for single-mode G.657.A1 fiber. Clean connector endfaces before mating to minimize insertion loss and contamination. Plug LC connectors into compatible LC ports on patch panels, transceivers or adapters, ensuring APC-polished connectors are aligned properly to maintain return-loss performance. Avoid excessive tension and secure the cable with appropriate strain relief at termination points.

Usage recommendations

For best optical performance, clean connectors with lint-free wipes and approved fiber cleaning tools before each connection, verify insertion and return loss after installation, and avoid sharp bends or crushing. Use the LSZH sheath cable in indoor and enclosed spaces where low smoke and halogen-free behavior is required.