SFP+ transceiver module CBO 330-2404 — 10 Gbit/s, 1310 nm

The SFP+ transceiver module CBO 330-2404 — 10 Gbit/s, 1310 nm is a compact, hot-pluggable optical module designed for 10 Gbit/s fibre links. It supports transmission over the 1310 nm wavelength and is intended for insertion into compatible SFP+ ports on switches, routers and network interface cards. The module enables short- to mid-range single-mode optical connections and is suited for data center uplinks, server connections and inter-switch links where a reliable 10 Gbit/s link is required.

Advantages

The module offers a standardized SFP+ form factor that simplifies field replacement and upgrades without powering down equipment. It delivers consistent 10 Gbit/s throughput with low power consumption and stable optical performance at 1310 nm. Compact dimensions and industry-standard compliance ensure broad compatibility with networking hardware that supports SFP+ transceivers, enabling straightforward deployment in rack-mounted and modular systems.

Suitable for

• 10 Gbit/s uplink and aggregation links in enterprise networks
• Server connections in data centers and colocation facilities
• Inter-switch fiber links and stackable switch interconnects
• Short- to mid-range single-mode fiber connections over 1310 nm

Key specifications

• Data rate: 10 Gbit/s
• Operating wavelength: 1310 nm
• Form factor: SFP+ hot-pluggable
• Connector type: LC duplex (typical for SFP+ optical modules)
• Optical reach: short- to mid-range single-mode fiber (dependent on fiber type and link budget)
• Power consumption: low (typical values depend on device implementation)
• Operating temperature range: industry-standard commercial range (refer to equipment specifications for exact values)

How to use

Install the transceiver into an empty SFP+ port on a powered network device by aligning the module with the port and pressing in until it clicks into place. Connect LC duplex fiber cables to the module ensuring correct transmit/receive orientation. Verify link status on the host device and configure the interface parameters in the switch, router or NIC as required by the network. To remove the module, follow the device vendor instructions for hot-plug removal and pull the latch or release mechanism before extracting the transceiver.

Usage recommendations

Ensure compatibility with the host device by confirming support for third-party SFP+ modules and matching optical parameters. Use quality single-mode fiber and clean connectors to maintain signal integrity. Observe electrostatic discharge precautions when handling the module and store unused transceivers with dust caps fitted. For critical links, verify link budget and fiber attenuation to confirm the module meets reach requirements.