CBO AOC Cable for Dell Networking 470-ABPM QSFP28 100G

CBO AOC Cable for Dell Networking 470-ABPM QSFP28 100G is an active optical cable compatible with Dell networking equipment that supports QSFP28 interfaces and delivers a 100 Gigabit per second data rate. It is engineered for short- to medium-reach links inside racks and between adjacent racks, offering low-latency optical connectivity intended for high-density server, switch and data center interconnects. The cable provides a factory-terminated, plug-and-play solution that removes the need for separate transceivers and multimode fiber patching in supported environments.

Advantages

This active optical cable reduces power consumption compared with some pluggable transceiver plus patch-cord combinations while maintaining high throughput and low latency. The integrated QSFP28 connector and fixed-length optical assembly simplify installation and reduce points of failure. Its compatibility with Dell Networking interfaces allows straightforward integration into existing 100 Gigabit Ethernet aggregation and spine-leaf topologies, and the cable’s optical design supports reliable signal integrity over short to medium distances typical for data center topologies.

Suitable for

• High-density server to switch connections within the same rack or neighboring racks
• Switch-to-switch aggregation and spine links in leaf-spine architectures
• Data center interconnects requiring 100 Gigabit Ethernet with low latency
• Backbone links and uplinks for enterprise and colocation environments

Key specifications

• Interface: QSFP28 connector
• Nominal data rate: 100 Gbps
• Type: Active Optical Cable (AOC)
• Typical reach: short to medium distances within data center environments
• Form factor: factory-terminated, plug-and-play cable assembly
• Use case: designed for server, switch and data center interconnects

How to use

Install the cable by plugging each QSFP28 connector into the corresponding QSFP28 port on compatible Dell Networking switches or other QSFP28-capable devices. Ensure devices are powered down or ports are configured per vendor guidance if hot-plug procedures are specified by the equipment manufacturer. After insertion, verify link status and speed through network management tools or device LEDs, and confirm that firmware or management settings recognize the 100G link. Route the cable to avoid tight bends and secure it to prevent strain on connectors.

Usage recommendations

Use this AOC for intra-rack and adjacent-rack 100G connections where short- to medium-range optical links are required. Avoid exceeding manufacturer-recommended bend radii and protect the cable from sharp edges and excessive mechanical stress. For mixed-vendor environments, confirm compatibility with your switch firmware and port optics policy before deployment.