SFP+ Transceiver Module CBO 801146 — 10 Gbit/s, 1310 nm

The SFP+ Transceiver Module CBO 801146 — 10 Gbit/s, 1310 nm is a compact optical transceiver designed for 10 Gigabit Ethernet links. It operates at a wavelength of 1310 nm and fits into standard SFP+ ports to provide high-speed optical connectivity. The module supports long-reach single-mode or multimode links where the host system and optical infrastructure allow, making it suitable for uplinks between switches, connections to aggregation layers, and high-speed server interfaces in data center environments.

Advantages

This BlueOptics SFP+ transceiver offers 10 Gbit/s line rate and a 1310 nm operating wavelength for extended optical reach. Its small form factor enables easy insertion into SFP+ ports and hot‑swapping in compatible equipment. The device is engineered for interoperability with common network switches and servers, providing predictable latency and stable throughput for Ethernet traffic. Low power consumption and standardized SFP+ mounting simplify deployment and maintenance in rack and blade systems.

Suitable for

• Data center uplinks between switches and routers
• Core and aggregation layer connections
• 10G server network interfaces and direct server-to-switch links
• Long-reach optical links over single-mode or supported multimode fiber

Key specifications

• Data rate: 10 Gbit/s
• Optical wavelength: 1310 nm
• Form factor: SFP+
• Compatibility: standard SFP+ ports (host-dependent support for single-mode or multimode links)
• Typical power consumption: low profile for SFP+ class devices
• Connector type: LC duplex (optical)

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch, router or network adapter until it latches. Connect LC duplex fiber patch cables matching the fiber type supported by your system (single-mode for long-reach links at 1310 nm, or multimode when supported). Verify the link status in the host device management interface and ensure both ends use compatible data rate and wavelength settings. For hot‑swap operations, follow the equipment vendor’s guidance to avoid transient link disruption where required.

Usage recommendations

Use single-mode fiber for maximum reach at 1310 nm and ensure transceiver compatibility with the host device firmware. Keep fiber connectors clean and inspect LC ferrules before mating to reduce signal loss. Monitor link parameters via the switch or server management tools to confirm stable operation and replace the module if persistent errors or link instability are observed.