SFP transceiver module BlueOptics AA1419071-E6 1250 Mbit/s 1550 nm

The BlueOptics AA1419071-E6 1250 Mbit/s 1550 nm is an SFP fiber optic transceiver module designed for use in data communications equipment. It provides a single-channel optical interface with a nominal wavelength of 1550 nm and supports a maximum data transfer rate of 1250 Mbit/s. The module is compact and lightweight (approximately 20 g) with a silver housing, suitable for installation in networking switches, routers or media converters that accept SFP form-factor modules.

Advantages

This SFP transceiver offers a standard small form-factor plug-in design that simplifies hot-swappable installation and replacement. Operating at 1550 nm, it is appropriate for longer-reach single-mode fiber links where that wavelength is required. The module’s 1250 Mbit/s speed supports common gigabit and legacy interfaces and its low weight and compact dimensions reduce mechanical strain on equipment slots. The silver metal housing provides durable protection for optical and electronic components.

Suitable for

• Single-mode fiber links requiring 1550 nm wavelength
• Networking equipment with SFP ports (switches, routers, media converters)
• Point-to-point fiber connections and metro access links
• Upgrading or replacing existing SFP transceivers

Key specifications

• Interface type: SFP small form-factor pluggable
• Nominal wavelength: 1550 nm
• Maximum data transfer rate: 1250 Mbit/s
• Typical application: single-channel optical transmission over single-mode fiber
• Housing colour: silver
• Weight: approximately 0.02 kg

How to use

Install the BlueOptics SFP transceiver into an available SFP port on compatible network equipment following the vendor’s hot-swap guidelines. Ensure the device is powered and port settings match the intended link speed and duplex configuration. Connect an appropriate single-mode optical fiber patch cable to the transceiver’s optical interface, observing correct connector type and polarity. After connection, verify link status through the network device management interface and monitor signal levels and error counters to confirm a stable optical link.

Usage recommendations

Handle the optical connector with care to avoid contamination; keep protective caps on when not in use and clean connectors according to best practices. Confirm compatibility of the transceiver with host devices and fiber type before deployment. For long-distance links using 1550 nm, consider optical budget and any required amplification or dispersion management depending on link length and fiber characteristics.