SFP28 Optical Transceiver CBO AOC SFP28 BlueOptics BO272703Q5M 100G 5M

The SFP28 Optical Transceiver CBO AOC SFP28 BlueOptics BO272703Q5M 100G 5M is an active optical cable assembly that delivers 100 Gigabit Ethernet connectivity over a fixed 5-meter fiber link. Built in an SFP28 form factor, this BlueOptics module is intended for short-reach, high-bandwidth interconnects between switches, routers and servers in data center and enterprise environments. The plug-and-play design provides immediate link establishment with minimal configuration, while the active optics enable low-latency, reliable transmission for demanding networking applications.

Advantages

This AOC provides a compact, energy-efficient alternative to discrete transceivers plus separate fiber patch cords by integrating transceiver electronics with the fiber cable. The fixed 5 m length reduces cable management complexity and helps maintain predictable signal integrity in dense rack deployments. SFP28 compatibility ensures broad interoperability with 100G ports that support SFP28 AOC modules, and the active design supports stable performance with low latency and consistent throughput.

Suitable for

• Short-reach uplinks between top-of-rack and aggregation switches
• High-speed server-to-switch connections in rack environments
• Interconnects within data center pods and network closets
• Applications requiring low-latency 100G links and simplified cabling

Key specifications

• Form factor: SFP28 active optical cable (AOC)
• Data rate: 100 Gigabit Ethernet
• Cable length: 5 meters (fixed)
• Optical interface: duplex fiber within an integrated cable assembly
• Operating mode: short-reach active optical link for intra-rack/inter-rack connections
• Latency: low-latency design suitable for high-throughput switching and server interconnects
• Power consumption: optimized for SFP28 module class (device firmware and hardware-dependent)
• Compatibility: designed for 100G ports that accept SFP28 AOC modules

How to use

Install the AOC by inserting each SFP28 connector into the corresponding 100G port on network devices until the connectors click into place. Ensure both ends are seated securely and that the host devices recognize the link; most systems detect the module automatically. Verify link status and speed via device management interfaces and configure network settings as required for VLANs, MTU, or link aggregation. For removal, release the connector latches where present and pull straight out to avoid stressing the cable or port.

Usage recommendations

Route and secure the 5 m active optical cable to avoid sharp bends and mechanical strain; maintain the manufacturer’s minimum bend radius to preserve optical performance. Use this AOC for short-reach 100G connections in controlled data center environments and confirm compatibility with the switch or server vendor’s supported transceiver list when deploying in production networks.