SFP Transceiver CBO AFCT-5715ALZ 155 Mbps 1310 nm

The SFP Transceiver CBO AFCT-5715ALZ 155 Mbps 1310 nm is a compact, hot-pluggable optical module intended for single-mode fiber links. It supports a data rate of 155 Mbps over a 1310 nm wavelength, making it suitable for metro and access network segments. The module is designed for insertion into SFP ports of switches, routers and other optical network equipment to provide reliable single-fiber connections with straightforward installation and minimal configuration.

Advantages

This BlueOptics SFP transceiver provides stable optical performance at 1310 nm with low power consumption and a compact SFP form factor. Its hot-pluggable design allows for insertion and replacement without powering down host equipment, simplifying maintenance and upgrades. The module offers compatibility with standard SFP interfaces and supports typical environmental operating ranges for network equipment used in indoor network closets and distribution cabinets.

Suitable for

• Extending single-mode fiber links in metro and access networks
• Replacing or upgrading SFP modules in switches and routers
• Point-to-point fiber connections between network devices
• Network equipment in data centers, telecom closets, and aggregation sites

Key specifications

• Form factor: Small Form-Factor Pluggable (SFP)
• Data rate: 155 Mbps
• Wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Connector type: LC duplex compatible interface
• Operation: Hot-pluggable
• Typical use: Metro and access network links

How to use

Install the SFP transceiver into an empty SFP slot on a compatible switch, router or optical device until it seats securely. Connect single-mode fiber with an LC connector to the transceiver’s optical interface, observing proper fiber handling and cleanliness to avoid signal loss. Configure the host device for the intended 155 Mbps link if required by the device’s management interface. For maintenance, use hot-swap procedures supported by the host: remove the module carefully and insert a replacement without powering down the equipment when allowed by the system.

Usage recommendations

Ensure fiber connectors are clean before mating and verify link settings on host equipment. Use appropriate single-mode patch cords and avoid bending fiber beyond recommended radii. For long-term reliability, operate the transceiver within the environmental limits specified by the host device and perform periodic inspection for dust or contamination on optical interfaces.