SFP Fiber Optic Transceiver CBO AT10078-0D-R-NN — SFP module, optical interface

The SFP Fiber Optic Transceiver CBO AT10078-0D-R-NN — SFP module, optical interface is a small form-factor pluggable module designed to provide optical connectivity for compatible network equipment. It converts electrical signals from devices such as switches, routers and telecom interfaces into optical signals for transmission over fiber, enabling secure, low-loss data links. The module fits standard SFP ports and is intended for installation where a compact, hot‑swappable optical interface is required.

Advantages

This SFP optical transceiver offers a compact SFP form factor that supports straightforward hot‑swappable replacement or installation without powering down equipment. It provides reliable fiber connectivity with low insertion loss and is suitable for short- to medium-range optical links depending on the installed fiber and network design. The module maintains standard electrical and optical interfaces to ensure compatibility with a wide range of networking devices that accept SFP modules.

Suitable for

• Adding or replacing optical ports on enterprise switches and routers
• Connecting fiber links in data center patch panels and telecom racks
• Extending network links between floors or buildings using fiber
• Deployment in managed network environments requiring standard SFP modules

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Interface type: optical SFP port for fiber connections
• Compatibility: designed for use in equipment that supports standard SFP modules
• Connector: fiber optical connector (type depends on installed cable and network setup)
• Hot‑swappable: supports insertion and removal without powering down host equipment
• Application: single-channel optical transceiver for data transmission over fiber

How to use

Install the transceiver into an empty SFP slot on compatible network equipment until it latches securely. Connect the appropriate fiber cable to the transceiver’s optical connector, observing fiber type and connector polarity. After insertion and cabling, verify link status through the host device’s management interface and LED indicators. To remove, disable the port if required by the host device, unlatch the SFP module and gently pull it from the slot, protecting the optical interfaces with dust caps when not in use.

Usage recommendations

Ensure that the fiber type (single-mode or multi-mode) and connector type match the installed network cabling and that transceiver specifications align with required link distance and data rate. Use dust caps when the module is not connected and follow ESD precautions during handling. Verify vendor and equipment compatibility where devices enforce vendor checks for SFP modules.