SFP+ transceiver module BlueOptics BO35J13610D-AL 10000 Mbit/s 1310 nm

The BlueOptics BO35J13610D-AL is an SFP+ transceiver module for single‑mode fiber networks, supporting data rates up to 10,000 Mbit/s and operating at a 1310 nm wavelength. The module uses an LC duplex connector and implements the 10GBASE‑LR optical interface for links up to approximately 10 km when used with appropriate single‑mode fiber. It is compact, lightweight (about 20 g) and designed for plug‑and‑play installation in compatible SFP+ ports that accept MSA‑compliant modules. The product complies with CE and RoHS requirements and supports standard network protocols such as Ethernet and Fibre Channel over appropriate physical layers.

Advantages

The transceiver provides 10 Gbit/s optical connectivity with a 1310 nm transmitter and receiver pair designed for long‑reach single‑mode links. Full MSA compatibility ensures mechanical and electrical interoperability with many vendor platforms, while support for Digital Diagnostic Monitoring (DDM/DOM) enables remote readout of temperature, supply voltage, laser bias current and optical power where host hardware supports these functions. Constructed from high‑quality optical and electronic components, the module offers a small form factor and low weight for easy handling and installation.

Suitable for

• 10 Gbit/s single‑mode fiber links up to ~10 km
• Switches and routers with SFP+ slots that accept MSA‑compliant modules
• Storage area networks and Fibre Channel deployments requiring 10G optical ports
• Network uplinks, aggregation and campus backbone connections

Key specifications

• Interface type: SFP+ (MSA compliant)
• Nominal data rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 1310 nm (Tx/Rx)
• Connector: LC duplex
• Compatible fiber type: single‑mode fiber
• Typical reach: up to ~10 km (depends on fiber and link budget)
• Digital Diagnostics: DDM/DOM support (if host supports)
• Weight: approximately 0.02 kg
• Product colour: silver
• Standards compliance: CE, RoHS

How to use

Install the transceiver into an empty SFP+ port on compatible network hardware, ensuring proper orientation and seating until the latch engages. Connect an LC duplex single‑mode patch cable between this module and the remote transceiver or patch panel. Verify link status via the host device management interface; enable DDM/DOM monitoring in the host if real‑time diagnostics are required. Follow the hardware vendor’s instructions for hot‑swap handling and ESD precautions during installation or removal.

Usage recommendations

Use certified single‑mode fiber and LC duplex patch cords matched to the module’s link budget to achieve the stated reach. Confirm that the target device accepts third‑party SFP+ modules and that firmware or configuration does not restrict module operation. Maintain proper ESD protection and avoid mechanical stress on the fiber connectors to ensure stable optical performance.