Network Transceiver Module CBO ITFZTCHLR-BO 10G SFP+ 1310 nm Singlemode

CBO ITFZTCHLR-BO 10G SFP+ 1310 nm Singlemode is a pluggable optical transceiver module designed for 10 Gigabit Ethernet links over singlemode fiber. It operates at a central wavelength of 1310 nm and fits SFP+ ports on switches, routers and servers to provide uplink and aggregation connectivity. The module supports hot-pluggable installation and is intended for short-to-medium singlemode fiber runs where compact, high-speed interfaces are required.

Advantages

The transceiver offers a compact SFP+ form factor that reduces space requirements in network equipment while delivering 10 Gbps throughput. Operating at 1310 nm on singlemode fiber ensures stable performance and low attenuation across typical campus and data center links. Hot-swap capability simplifies maintenance and replacement without disrupting powered devices. The device’s compatibility with standard SFP+ ports enables flexible use across a range of switches, routers and servers that support 10 Gigabit Ethernet optics.

Suitable for

• 10 Gigabit Ethernet uplinks between switches in campus or data center environments
• Aggregation links connecting distribution and core network devices
• Server network interfaces requiring compact 10G SFP+ optics
• Short-to-medium distance singlemode fiber connections using 1310 nm optics

Key specifications

• Form factor: SFP+ (small form-factor pluggable)
• Maximum data rate: 10 Gbps
• Operating wavelength: 1310 nm
• Fiber type: singlemode fiber
• Typical reach: short-to-medium singlemode distances (manufacturer guidance applies)
• Interface: duplex LC connector
• Hot-pluggable design for in-service replacement

How to use

Install the SFP+ transceiver into an available SFP+ port on the network device until it clicks into place, then connect the singlemode duplex LC fiber cable matching transmit/receive orientation. Ensure the connected switch, router or server port is configured for 10 Gigabit Ethernet and that both ends use compatible 1310 nm singlemode optics. When removing the module, power down the interface or administratively disable the port if required by the device, then release the module using the built-in latch and pull it straight out to avoid damage to the connector.

Usage recommendations

Use quality singlemode duplex LC fiber cable and adhere to the network equipment vendor’s compatibility list to ensure reliable link establishment. Verify optical power budgets and link distance suitability for 1310 nm operation before deployment. Handle the transceiver and fiber connectors with care to avoid contamination; use dust caps when the module or cable is disconnected.