SFP+ transceiver BlueOptics J9150D-BO 10GBASE-SR 850nm 300m

The BlueOptics J9150D-BO SFP+ transceiver is a hot-pluggable optical module designed for short-range 10 Gigabit Ethernet (10GBASE-SR) links over multimode fiber. Operating at a wavelength of 850 nm, this module supports a maximum reach of up to 300 meters (depending on fiber type and deployment conditions) and is intended for use in SFP+ ports of switches, servers and optical adapters. Its form factor and electrical interface comply with SFP+ standards to enable straightforward integration into data center uplinks and local network interconnects.

Advantages

The transceiver offers standardized 10GBASE-SR performance with compatibility for common multimode fiber installations and short-reach data center use. Its SFP+ form factor provides a compact, hot-swappable solution that simplifies maintenance and upgrades without requiring system downtime. The module’s optical specification reduces complexity for server-to-switch and switch-to-switch connections while supporting industry-standard signaling for reliable 10 Gbps throughput.

Suitable for

• 10 Gigabit Ethernet short-range links over multimode fiber
• Data center uplinks between aggregation and access switches
• Server-to-switch and switch-to-switch interconnections within racks or between adjacent rooms
• LAN segments requiring 10 Gbps bandwidth with distances up to 300 meters

Key specifications

• Interface: SFP+ electrical and mechanical form factor
• Standard: 10GBASE-SR optical Ethernet
• Wavelength: 850 nm
• Maximum reach: up to 300 meters over suitable multimode fiber
• Fiber type: multimode fiber (MMF)
• Hot-pluggable: yes
• Data rate: 10 Gbps

How to use

Install the transceiver into an available SFP+ port on your switch, router or network interface card, ensuring the module is fully seated and latched according to the host device instructions. Connect the multimode fiber patch cable with the appropriate connector type, observing correct transmit/receive orientation. Verify link status and speed through the host device’s management interface or status LEDs. When removing the module, power down the port if recommended by the system vendor and extract the transceiver using the built-in latch or release mechanism to avoid damage.

Usage recommendations

Use high-quality OM3 or OM4 multimode fiber to achieve the specified reach and consistent 10 Gbps performance. Avoid bending the fiber beyond recommended bend radii and keep connector endfaces clean to maintain optical signal integrity. Confirm host compatibility with SFP+ 10GBASE-SR modules and follow equipment vendor guidelines for firmware and supported transceiver lists.