BlueOptics D108B network transceiver module Fiber optic 10000 Mbit/s XFP 1310 nm

The BlueOptics D108B network transceiver module Fiber optic 10000 Mbit/s XFP 1310 nm is a hot-pluggable optical module designed to enable 10 Gbps data transmission over single-mode fiber links. With an XFP interface and a nominal operating wavelength of 1310 nm, this module integrates into compatible networking equipment to extend fiber reach and support high-bandwidth applications. The compact form factor and standardized electrical/optical interfaces allow straightforward replacement or upgrade in switches, routers or transport systems that accept XFP modules.

Advantages

The module supports a maximum data transfer rate of 10000 Mbit/s and complies with XFP interface specifications, providing reliable, low-latency optical connectivity. Operating at 1310 nm, it is suitable for single-mode fiber links over medium to long distances while maintaining stable optical performance. Its plug-and-play design simplifies installation and maintenance without requiring major configuration changes on host devices.

Suitable for

• Upgrading 10 Gbps fiber links in enterprise and data center networks
• Interchangeable use in switches, routers and optical transport equipment with XFP slots
• Applications requiring single-mode fiber transmission at 1310 nm
• Replacing or provisioning optical interfaces for high-throughput network segments

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Operating wavelength: 1310 nm
• Form factor: XFP optical transceiver module
• Connectivity: Single-mode fiber support

How to use

Before installing, verify that the host device supports XFP modules and that the link budget and fiber type match single-mode 1310 nm operation. Power down or follow the vendor-recommended hot-swap procedure for your equipment, insert the module into an available XFP slot until it engages, and connect the single-mode fiber patch cable to the transceiver's optical port. Bring the interface up via the host device configuration if necessary and check link status and error counters to confirm correct operation.

Usage recommendations

Use appropriate ESD precautions when handling the transceiver and keep protective dust caps on the optical connectors until final connection. Ensure fiber connectors are clean and the link distance is within the optical power budget for 1310 nm single-mode transmission. Refer to the host equipment documentation for compatibility and any required firmware or configuration settings.