SFP+ Transceiver BlueOptics JW148A-BO 10GBASE-ZR 80 km LC-Duplex SMF 1550 nm DDM

BlueOptics JW148A-BO is an SFP+ optical transceiver module engineered to support 10GBASE-ZR links over single-mode fiber up to 80 km. It operates at a 1550 nm wavelength and uses an LC-duplex connector, offering digital diagnostics monitoring (DDM) for real-time visibility of optical parameters. The module is intended for deployment in 10 Gigabit Ethernet environments, long-haul and DWDM-enabled networks where extended reach and reliable signal integrity are required.

Advantages

The transceiver provides long-reach performance with support for distances up to 80 km on single-mode fiber, enabling connectivity between distant network sites without intermediate amplification. Its 1550 nm wavelength is suitable for reduced attenuation over long spans, and the LC-duplex interface ensures wide compatibility with standard fiber patching. Integrated DDM allows monitoring of transmit/receive power, temperature, voltage and bias current to aid fault detection and maintenance.

Suitable for

• 10 Gigabit Ethernet links in data centers and metro/core networks
• Long-haul point-to-point single-mode fiber connections up to 80 km
• DWDM and carrier access applications requiring 1550 nm transceivers
• Network upgrades where monitoring of optical parameters is needed

When it may not be suitable

This SFP+ transceiver is not intended for multimode fiber installations or for short-reach 10GBASE-SR applications that use different wavelengths and connectors. It may also be unnecessary for short-distance links where lower-cost short-range modules are sufficient. Ensure the host device supports SFP+ 10GBASE-ZR modules and the required optical power budget before deployment.

Key specifications

• Form factor: SFP+ (10 Gbps)
• Supported standard: 10GBASE-ZR
• Maximum reach: up to 80 km over single-mode fiber
• Wavelength: 1550 nm
• Connector type: LC-duplex
• Monitoring: Digital Diagnostics Monitoring (DDM)

How to use

Install the SFP+ transceiver into a compatible SFP+ port on a switch, router or media converter while the host device is powered according to the vendor’s hot-swap instructions. Connect LC-duplex single-mode fiber patch cables between transceivers at each end of the link, observing correct Tx/Rx polarity. After physical installation, verify link status and check DDM readouts in the host management interface to confirm optical power, temperature and module health. Follow standard fiber handling procedures to avoid contamination of connectors and transceiver ports.

What to consider before purchase

• Compatibility of the host device with SFP+ 10GBASE-ZR modules
• Optical power budget and link loss for the intended fiber route up to 80 km
• Connector type (LC-duplex) and required fiber type (single-mode)
• Requirement for digital diagnostics monitoring (DDM) in your monitoring tools

Usage recommendations

Handle the module by its housing, keep connector end-faces clean, and verify Tx/Rx polarity before powering the link. Use the DDM data to monitor changes in optical power and temperature over time to detect degradation or alignment issues on long-haul links.