CBO QSFP28 100Gbit/s BlueOptics MCP7F00-A005R26L 5m fiber cable

Direct-attach fiber cable CBO BlueOptics MCP7F00-A005R26L is a 5 m QSFP28 assembly engineered for 100 Gbit/s short-reach links. The cable connects QSFP28 ports and is intended for high-density data center and enterprise network environments where low latency and high throughput are required. Its fixed-length design simplifies installation for switch-to-switch, server-to-switch or patch-panel connections while maintaining signal integrity for 100GbE applications.

Advantages

The QSFP28 100Gbit/s assembly offers a compact QSFP28 connector interface and a 5 m length that balances reach and manageability in rack deployments. It delivers reliable, low-latency transmission with performance suitable for short-reach 100GbE links and minimizes the need for intermediate transceivers. The cable is pre-terminated to reduce installation time and potential connector errors, and its construction supports consistent optical performance across typical data center operating conditions.

Suitable for

• Short-reach 100 Gigabit Ethernet connections between switches
• Direct server-to-switch 100GbE links in data centers
• High-density rack and top-of-rack (ToR) connectivity
• Interconnects in enterprise aggregation and spine-leaf architectures

Key specifications

• Connector type: QSFP28 to QSFP28
• Maximum data rate: 100 Gbit/s
• Length: 5 m
• Transmission mode: short-reach multimode fiber assembly
• Use case: direct-attach for 100GbE links

How to use

Insert each QSFP28 connector into the corresponding QSFP28 port on your network devices until the latch engages. Ensure both ends are fully seated and that cable routing avoids sharp bends and mechanical stress. For best performance, verify port configuration and link negotiation on your switches or servers, then monitor link status to confirm the 100GbE connection is active. If necessary, consult device documentation for specific port enabling or DAC recognition settings.

Usage recommendations

Install the 5 m cable in rack layouts that keep cable runs tidy and minimize bend radius; avoid kinking and maintain separation from power cables. Use this direct-attach assembly for short-reach 100GbE links where transceiver-based solutions are not required. Regularly inspect connectors for contamination and clean with appropriate fiber-optic cleaning tools before insertion to preserve signal quality.