Transceiver CBO OMMD15N00 QSFP 25G fiber optic module

CBO OMMD15N00 QSFP 25G fiber optic module is a compact transceiver designed for reliable 25 Gigabit Ethernet links in data center and enterprise network equipment. Offered in a QSFP form factor, this BlueOptics transceiver provides a cost‑effective solution for upgrading switches, routers and line cards to higher port speeds while maintaining compatibility with standard QSFP ports. The module is intended for short‑ to medium‑range optical connections and supports hot‑swapping in compatible systems.

Advantages

The transceiver delivers stable 25G optical connectivity with low power consumption and a compact QSFP footprint. It is backward compatible with common QSFP cages and host boards, which simplifies integration into existing network infrastructure. Built to industry optical and mechanical standards, the module ensures predictable link performance and consistent signal integrity for demanding traffic loads.

Suitable for

• Upgrading 10G/40G switch ports to 25G in data center top-of-rack and spine deployments
• High‑speed interconnects between switches, routers or servers within the same facility
• Carrier and enterprise aggregation links for increased per‑port bandwidth

Key specifications

• Interface: QSFP form factor supporting 25G per channel operation
• Data rate: 25 Gigabit Ethernet optical transmission
• Optical range: suitable for short‑ to medium‑reach multimode/singlemode links (refer to vendor distance classes)
• Connector type: fiber optic duplex/quad solutions compatible with QSFP cages
• Power consumption: low-power design optimized for dense port deployments
• Operating temperature: designed for typical data center operating ranges

How to use

Insert the QSFP transceiver into a compatible QSFP port on a powered‑down or hot‑swap capable switch or router until it clicks into place. Connect the appropriate fiber patch cable to the module’s optical interface, ensuring correct polarity and connector type. When installed in supported equipment, the transceiver is identified by the host device and negotiated for the correct 25G link. Monitor link status via the switch or router management interface and verify optical levels where available.

Usage recommendations

Use multimode or singlemode fiber and patch cables that match the transceiver’s optical class and the distance requirements of your link. Follow manufacturer guidance for ESD protection during handling and ensure firmware and hardware compatibility with the host device. For densest deployments, plan power and cooling to accommodate multiple transceivers in the same chassis.