BlueOptics QSFP-AOC-15M-IX-BO InfiniBand fibre optic cable 15m Male/Male

The BlueOptics QSFP-AOC-15M-IX-BO InfiniBand fibre optic cable 15m Male/Male is a 15-metre active optical cable designed for high-speed InfiniBand interconnects. It uses QSFP form-factor connectors on both ends and is intended for short- to mid-range links inside racks and between adjacent racks in data centres and high-performance computing setups. The cable supports low-latency, high-bandwidth data transmission required by storage arrays, compute clusters and network switches.

Advantages

This active optical cable provides consistent signal integrity over a 15 m distance while offering the compact QSFP connectivity commonly used in InfiniBand environments. Because it is an optical assembly, it reduces electromagnetic interference and heat generation compared with copper alternatives and enables higher data rates with lower power per bit. The male-to-male QSFP termination ensures straightforward plug-and-play installation with compatible QSFP ports.

Suitable for

• Short- to mid-range InfiniBand links within data centre racks
• Interconnects between compute nodes and storage systems
• High-performance computing clusters and low-latency networking
• Connections between switches and QSFP-enabled network devices

Key specifications

• Cable type: active optical cable (AOC)
• Connector type: QSFP male to QSFP male
• Length: 15 metres
• Application: InfiniBand high-speed interconnects
• Advantages: low electromagnetic interference, low heat dissipation
• Typical use environment: data centre racks, HPC clusters

How to use

Ensure both endpoints have compatible QSFP ports and that devices are powered off or can accept hot-plugging per vendor guidance. Align the QSFP connectors with the device ports and insert gently until the latch engages. Confirm link activity and negotiated data rate via system management tools or device LEDs. For removal, release the connector latch and withdraw the plug straight out to avoid stress on the cable. Route the cable to avoid sharp bends and secure it to prevent strain on the connectors.

Usage recommendations

Handle the cable by the connector housings and maintain minimum bend radius specified by the manufacturer. Keep optical interfaces clean and covered when not connected. Use AOC assemblies of the appropriate length to minimise excess cabling in rack environments and verify firmware and compatibility of QSFP ports when integrating into existing InfiniBand fabrics.