Network transceiver module CBO S26361-F3986-L4-BO 10,000 Mbit/s 1310 nm

CBO S26361-F3986-L4-BO is a network transceiver module designed for fiber-optic links, supporting a data rate of 10,000 Mbit/s and operation at a wavelength of 1310 nm. It provides plug-in compatibility with compatible optical ports to enable high-speed connectivity between switches, routers and servers. The module is intended for short- to medium-range optical transmission in data centers and enterprise networks where reliable 10 Gbps links are required.

Advantages

The transceiver delivers a stable 10,000 Mbit/s throughput over single-mode fiber at 1310 nm, ensuring low-latency data transfer for networked systems. Its hot-pluggable design simplifies installation and replacement without interrupting existing equipment. The compact form factor reduces space requirements in dense rack environments and is compatible with standard SFP+ interfaces for straightforward integration into existing network hardware.

Suitable for

• 10 Gbps uplinks between switches in data center aggregation layers
• High-speed connections between routers and core switches
• Server-to-switch connectivity in enterprise server rooms
• Short- to medium-distance fiber runs within campus or building environments

Key specifications

• Nominal data rate: 10,000 Mbit/s
• Operating wavelength: 1310 nm
• Transmission medium: single-mode fiber (SMF)
• Interface type: SFP+ compatible hot-pluggable module
• Typical application range: short to medium optical distances

How to use

Install the transceiver module into a compatible SFP+ slot on your switch, router or server until it clicks into place. Connect the single-mode fiber cable with the appropriate connector type to the module’s optical port, ensuring clean fiber endfaces to minimize loss. Configure the network device ports as required for 10 Gbps operation and verify link status through the device management interface. For replacement, remove the module while the device remains powered if hot-pluggable support is provided, and insert the new module following the same steps.

Usage recommendations

Ensure fiber connectors are cleaned before insertion and use compatible single-mode patch cords rated for 1310 nm transmission. Verify compatibility with the host device’s SFP+ interface and review device firmware or vendor documentation for any required settings. Avoid bending fiber beyond recommended radii and keep operating environment within the equipment’s specified temperature and humidity ranges to maintain reliable optical performance.