Fiber Optic SFP+ Transceiver CBO SFP-10G-BX-U 10Gbps 1310nm

The BlueOptics Fiber Optic SFP+ Transceiver CBO SFP-10G-BX-U 10Gbps 1310nm is a compact, hot-pluggable module for single-mode fiber links. It supports a 10 Gbps data rate over a wavelength of 1310 nm and is intended for use in devices with SFP+ ports such as switches and routers. The module is suitable for uplink, metro and data center interconnect applications where a small form factor and easy replacement are required.

Advantages

This SFP+ transceiver provides a consistent 10 Gbps throughput with single-mode fiber compatibility at 1310 nm, offering low power consumption and a compact SFP+ form factor for dense installations. Hot-pluggable operation allows installation or replacement without powering down the host device. The module is designed for interoperability with standard SFP+ ports and supports stable performance for point-to-point fiber links in carrier and enterprise networks.

Suitable for

• 10 Gigabit uplinks between switches and routers
• Data center interconnects and server aggregation
• Metro fiber links and service provider edge connections
• Single-mode fiber point-to-point connections

Key specifications

• Data rate: 10 Gbps
• Operating wavelength: 1310 nm
• Fiber type: Single-mode
• Form factor: SFP+
• Hot-pluggable: Yes

How to use

Install the transceiver into an available SFP+ slot on a compatible switch or router until it latches. Connect single-mode fiber patch cables with the correct transmitter/receiver orientation, following the host device's port labeling. Observe standard electrostatic discharge precautions when handling the module. After insertion and fiber connection, verify link status via the host equipment's management interface and confirm that the port negotiates at 10 Gbps.

Usage recommendations

Use clean single-mode fiber connectors and inspect end-faces before mating to avoid contamination. For optimal performance, follow the host system's optics compatibility list and maintain ambient operating conditions within the device specifications. Replace or reseat the module only when the host system indicates a fault or during planned maintenance.