SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm

SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm is a 10 Gigabit optical module that operates at a 1310 nm wavelength. Designed for high-speed Ethernet and Fibre Channel links, this single-mode SFP+ transceiver supports long-reach connections and is compatible with equipment offering SFP+ ports. The module enables network upgrades and link extension for switches, routers and other optical network devices while maintaining 10G data throughput over single-mode fiber.

Advantages

The transceiver provides stable 10 Gigabit performance over long distances with low power consumption and a compact SFP+ form factor. It is engineered for interoperability with a wide range of network hardware that accepts SFP+ optics, offering predictable signal quality and reduced latency compared with lower-speed optics. The module’s wavelength and single-mode design make it suitable for extended reach deployments, enabling consolidation of network layers without changing existing fiber routes.

Suitable for

• 10G Ethernet uplinks between switches and core routers
• Long-reach Fibre Channel connections in SAN environments
• Data center interconnects over single-mode fiber
• Network upgrades where extended optical reach is required
• Telecom and carrier access links using 1310 nm wavelength

Key specifications

• Data rate: 10 Gigabit Ethernet
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ module
• Typical reach: long-reach links over single-mode fiber (application-dependent)
• Connector type: duplex LC compatible
• Power consumption: low-power SFP+ class (typical values vary by device)

How to use

Install the SFP+ transceiver into an available SFP+ port on a compatible switch, router or optical device. Ensure the system is powered down if required by the vendor, or follow hot-plug procedures supported by your hardware. Connect duplex single-mode fiber using LC connectors, taking care to match transmit and receive fibers. After insertion and fiber connection, verify link status and configure interface settings on the host device as needed (speed, duplex and any optical diagnostics). Monitor link LEDs and management interfaces to confirm stable operation.

Usage recommendations

Use this 1310 nm SFP+ transceiver in environments with properly installed single-mode fiber and compatible SFP+ ports. Avoid exposing the optical interface to dust and direct sunlight; keep protective caps on unused ports. For long-reach deployments, validate fiber attenuation and distance limits and consult device documentation for supported temperature and power characteristics.