SFP transceiver module BlueOptics SFP-10G-ZR-BI-BO 10000 Mbit/s 1550 nm

The BlueOptics SFP-10G-ZR-BI-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s single-mode links. Operating at a wavelength of 1550 nm, the module supports long-reach optical transmission and uses an LC duplex connector in a compact metal housing. The transceiver is compatible with devices that accept MSA-compliant SFP+ modules and is intended for use where reliable 10GBASE-ZR optical connectivity is required.

Advantages

This SFP+ module delivers 10,000 Mbit/s data transfer over single-mode fiber with a 1550 nm transmitter and receiver, enabling long-distance links. The metal casing provides mechanical stability and electromagnetic shielding while the low supply voltage (3.3 V) and lightweight construction reduce power and space requirements. The module is designed to comply with MSA standards and supports digital diagnostics (DDM/DOM) for remote monitoring of supply voltage, laser bias current, optical power and temperature when the host hardware provides support.

Suitable for

• Long-reach 10G Ethernet connections (10GBASE-ZR) over single-mode fiber
• High-speed links between switches, routers and storage systems
• Data center uplinks and long-distance telecom links
• Environments requiring DDM/DOM monitoring for remote diagnostics

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10,000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1550 nm (transmitter and receiver)
• Connector: LC duplex
• Transmission medium: single-mode fiber
• Typical supply voltage: 3.3 V
• Product colour: silver; housing: metal
• Weight: approx. 3 g
• Supports Digital Diagnostics Monitoring (DDM/DOM) per MSA SFF-8472 when supported by host

How to use

Install the SFP+ transceiver into a compatible SFP+ slot on a switch, router or other networking device following the device manufacturer's insertion and removal procedures. Connect single-mode LC duplex fiber patch cables to the module, observing correct Tx/Rx orientation. Ensure the host device firmware or software supports the module and, if needed, enable DDM/DOM monitoring to read real-time diagnostic parameters. Verify link status and speed after insertion and perform standard link testing to confirm signal quality.

Usage recommendations

Use single-mode fiber patch cords rated for 1550 nm and keep fiber connectors clean. Confirm compatibility with the target hardware and enable digital diagnostics if remote monitoring is required. For long-distance links, plan appropriate optical budgets and consider using recommended BlueOptics patch cables or patch panels to achieve optimal range and signal performance.