AOC active optical cable CBO for Alcatel-Lucent SFP-AOC-10G-50M 10 Gbps, 50 m

BlueOptics active optical cable CBO compatible with Alcatel-Lucent SFP-AOC-10G-50M provides a 10 Gbps full-duplex connection over a single pre-terminated cable up to 50 metres. The assembly integrates optical transceivers and multimode fiber in one lightweight cord, allowing direct SFP+ port-to-port links without separate transceiver modules or patch panels. It is intended for high-density environments where low latency, simplified cabling and consistent 10 Gbps performance are required between switches, routers and storage systems.

Advantages

The integrated design reduces component count and rack space by eliminating separate optic modules and patch cords, simplifying installation and inventory management. With a 50 m reach and 10 Gbps data rate, the cable supports common data centre and telecom topologies while providing lower power consumption compared with some active transceiver plus fiber combinations. The pre-terminated connector ends ensure predictable signal performance and reduce the need for field terminations or splicing.

Suitable for

• Short- to mid-range 10 GbE links between SFP+ ports in switches and routers
• Server-to-switch and storage-to-switch connections in data centres
• High-density rack installations where simplified cabling is required
• Telecom aggregation links and equipment interconnects requiring low latency

Key specifications

• Nominal data rate: 10 Gbps full duplex
• Maximum cable length: 50 metres
• Connector type: SFP+ form-factor active optical cable ends for direct port insertion
• Transmission medium: integrated multimode optical fiber with active electronics
• Typical use environment: data centre, telecom equipment racks and server rooms
• Compatibility: designed for SFP+ ports supporting 10 Gbps direct-attach optical links
• Cable construction: lightweight, flexible pre-terminated assembly for high-density routing

How to use

Install the active optical cable by inserting each SFP+ end into the corresponding SFP+ port of the networking devices until the connector latches. Ensure devices are powered down or follow hot-swap procedures recommended by the equipment vendor. Verify link status and speed in device management interfaces once both ends are connected. Route the cable to avoid tight bends and mechanical strain; maintain the minimum bend radius specified by the equipment documentation.

Usage recommendations

For reliable operation, use the cable within its rated 50 m length and in environments matching the equipment's operating temperature. Avoid routing near high-electrical-noise sources or mechanical pinch points. Confirm SFP+ port firmware and device compatibility if a link is not established immediately, and keep spare cables on hand for rapid replacement in high-availability installations.