Active Optical Cable CBO SFP28-AOC-10M 10 m — SFP28 DAC/AOC for 25GbE connections

Active Optical Cable CBO SFP28-AOC-10M (10 m) is a fixed‑length SFP28 AOC designed for 25GbE network links. The cable provides a single‑assembly optical connection between SFP28 ports on switches, routers and servers, delivering low latency and reduced power consumption compared with active copper alternatives. Its compact design reduces cable bulk in racks and eliminates the need for separate transceivers and fiber patch cords, simplifying installation in data centers and enterprise network closets.

Advantages

The SFP28 AOC offers a plug‑and‑play optical link with predictable performance over a 10 metre reach, lowering electromagnetic interference and improving signal integrity. Its integrated transceiver design reduces component count and streamlines inventory management. The cable supports the electrical and protocol requirements for 25 Gigabit Ethernet while consuming less power than many comparable direct‑attach copper solutions.

Suitable for

• Short‑reach interconnects between top‑of‑rack and leaf switches
• Server to switch connections in rack environments
• High‑density data center cabling where space and EMI reduction are priorities
• Connecting SFP28 ports in enterprise aggregation and distribution layers

Key specifications

• Interface type: SFP28 to SFP28
• Nominal data rate: compatible with 25 Gigabit Ethernet
• Connector: factory‑terminated optical connector assembly integrated in cable ends
• Cable length: 10 metres (fixed length)
• Transmission medium: active optical fiber with integrated transceiver electronics
• Latency: low, suitable for low‑latency networking applications
• Power consumption: lower than many active copper direct‑attach alternatives (AOC design)
• Form factor: compact, single‑cable assembly for SFP28 ports

How to use

Install the CBO SFP28‑AOC‑10M by inserting each SFP28 connector into the corresponding SFP28 port on network equipment until the latch engages. No separate transceivers or fiber patching is required. Verify link status and speed on connected devices after insertion and configure network interfaces according to your switch or server settings. For hot‑swap capable equipment, the cable can be inserted or removed while the systems are powered, following vendor guidelines.

Usage recommendations

Route the cable to avoid sharp bends and excessive mechanical stress; maintain the minimum bend radius specified by the manufacturer. Keep the connector end caps in place until installation to protect optical interfaces from contamination. Use the AOC for short‑reach 25GbE links within racks or between adjacent racks and ensure firmware and module compatibility with your networking equipment.