CBO AOC SFP28 BlueOptics BO272703Q2M 2 m active optical cable for 25Gb/s connections

The CBO AOC SFP28 BlueOptics BO272703Q2M is a 2 m active optical cable designed for SFP28 ports and 25Gb/s links. This AOC provides a direct, plug-and-play connection between compatible network devices, using an optical medium to reduce signal degradation over short multimode fiber runs. Its 2 metre length and thin cabling profile help maintain tidy racks and short-distance high-speed interconnects in server rooms and data centers while supporting the bandwidth demands of 25 Gigabit Ethernet environments.

Advantages

This BlueOptics active optical cable offers low insertion loss and immunity to electromagnetic interference compared with copper cables, enabling stable 25Gb/s performance over its 2 m span. The integrated SFP28 transceivers eliminate the need for separate optical modules, simplifying installation and inventory management. The cable’s light weight and flexible jacket reduce strain on ports and make routing in dense cable environments easier, while its factory-terminated connectors ensure consistent optical alignment and predictable link behaviour.

Suitable for (tasks / use cases)

• Server-to-switch connections in data centers
• Switch-to-switch interconnects in top-of-rack or leaf-spine architectures
• High-speed uplinks and short-distance optical fabric links
• Environments requiring reduced electromagnetic interference and compact cabling

Key specifications

• Connector type: SFP28 form-factor active optical cable
• Data rate: 25 Gb/s per link
• Length: 2 metres
• Medium: multimode active optical assembly
• Latency: low propagation delay suitable for short interconnects
• Compatibility: designed for SFP28-capable network ports supporting 25GbE
• Operating environment: intended for indoor data center and server room use

How to use

Install the cable by inserting each SFP28 connector into the corresponding SFP28 port on the linked devices until the latch engages. Ensure devices are powered and ports are enabled for 25Gb/s operation or auto-negotiation as required by your equipment. No separate transceivers or patch panels are necessary; the cable is factory-terminated and requires only mechanical connection. Verify link status through the devices’ management interfaces and check for proper link speed and error counters after connection.

Usage recommendations

Route the cable to avoid tight bends and mechanical strain; maintain the manufacturer’s minimum bend radius and avoid excessive tension. Use this 2 m AOC for short-range optical links within racks or between adjacent racks where 25Gb/s SFP28 ports are available. Confirm firmware and compatibility lists for your switches and servers to ensure seamless operation, and handle connectors by the housing to keep end faces clean; inspect and clean optical interfaces if link issues arise.