Fiber MTP to 4×LC Breakout Cable CBO SFP6141BU5MKB — Singlemode, 5 m

The BlueOptics Fiber MTP to 4×LC Breakout Cable CBO SFP6141BU5MKB — Singlemode, 5 m is a 5‑metre singlemode fiber breakout assembly that terminates an MTP multi‑fibre connector on one end and four LC connectors on the other. It is engineered for high‑density network environments where a single multi‑fibre trunk needs to be split into multiple LC ports for SFP transceivers, patch panels or fiber distribution frames. The cable supports singlemode transmission and is intended for point‑to‑point connections in data centre and telecom infrastructure.

Advantages

This breakout cable offers compact conversion from a multi‑fibre MTP trunk to four individual LC duplex connections, reducing rack and patch panel space requirements. Its singlemode construction minimises insertion loss over longer runs and maintains consistent optical performance for transceivers and optical equipment. The 5 m length provides a balance between reach and cable management in typical rack and cabinet layouts, and the factory‑polished connectors ensure reliable mating and repeatable connections.

Suitable for

• Connecting MTP trunks to 4×LC ports on SFP/SFP+ singlemode transceivers
• High‑density fibre patch panels and data centre spine‑to‑leaf cabling
• Telecom racks and central offices requiring compact fibre breakout
• Optical distribution frames and fibre consolidation points

Key specifications

• Fiber type: singlemode
• Connector A: MTP multi‑fibre connector (male or female depending on cable variant)
• Connector B: 4 × LC singlemode connectors
• Cable length: 5 m
• Polish type: factory polished endfaces for low insertion loss
• Cable jacket: slim profile for high‑density routing (typical jacket suitable for rack use)

How to use

Install the MTP end into the corresponding multi‑fibre trunk or cassette with correct orientation and secure latching. Route the breakout cable to the target equipment, then plug the four LC connectors into the designated transceiver ports or patch panel adapters, taking care to maintain correct polarity where required. Ensure gentle bends and strain relief to avoid microbending losses. Verify link continuity and optical power levels after connection to confirm proper installation.

Usage recommendations

Use this singlemode MTP to 4×LC breakout cable in environments with controlled bend radius and cable management. For optimal performance, match connector polishing and transceiver specifications, label both ends for easier troubleshooting, and avoid excessive pulling force. When inserting into MTP cassettes, check alignment keying to prevent connector damage.