SFP transceiver module BlueOptics SFPGLHX30-W-BO 1250 Mbit/s 1310 nm

The BlueOptics SFPGLHX30-W-BO is an SFP fiber optic transceiver module designed for single-mode links with a wavelength of 1310 nm and a maximum data transfer rate of 1250 Mbit/s. Housed in a stainless-steel casing and weighing approximately 20 g, this compact SFP module uses an LC duplex connector and follows MSA form-factor and electrical specifications. It is RoHS, CE and FCC certified and intended for use in compatible networking equipment that accepts standard SFP modules.

Advantages

This BlueOptics SFP transceiver supports 1000BASE-LH single-mode operation and provides bidirectional optical transmission at 1310 nm. The module is built to meet industry MSA standards for interoperability and physical fit, enabling plug-and-play replacement in hardware that supports compatible SFP modules. Low weight and a stainless-steel housing offer robust mechanical stability while maintaining a compact footprint. Certifications and adherence to quality controls ensure predictable performance in typical networking environments.

Suitable for

• Long-reach single-mode Ethernet links up to the module's supported range
• Interchangeable deployment in switches, routers and storage systems with SFP ports
• Upgrading or replacing existing 1000BASE-LH optical transceivers
• Optical backbone and interconnect links between network equipment

Key specifications

• Interface type: SFP (MSA-compliant)
• Data rate: up to 1250 Mbit/s (1.25 Gbps)
• Wavelength: 1310 nm (single-mode)
• Connector: LC duplex
• Housing: stainless-steel casing
• Weight: approximately 0.02 kg
• Certifications: RoHS, CE, FCC

How to use

Insert the BlueOptics SFPGLHX30-W-BO module into a compatible SFP port following the host device manufacturer’s hot-swap guidelines. Ensure the receiving equipment supports 1000BASE-LH SFP transceivers and the LC duplex fiber patch cable is correctly connected for transmit and receive pairs. After insertion, verify link status and negotiate network speeds according to the switch or router interface settings. Observe ESD precautions when handling the module and keep protective dust caps on the fiber connector when not in use.

Usage recommendations

Use single-mode fiber patch cords matched to the 1310 nm wavelength and high-quality LC duplex connectors to achieve optimal link performance. Confirm compatibility with the host device for DDM/DOM support if real-time diagnostic monitoring is required. Store and operate the module within the equipment manufacturer’s specified temperature and humidity ranges and replace protective caps when the module is not connected to prevent contamination.