SFP+ transceiver BlueOptics SFPP-10G-LRT2-C-BO 10000 Mbit/s 1310 nm

The BlueOptics SFPP-10G-LRT2-C-BO is an SFP+ fiber-optic transceiver module designed for 10 Gbit/s optical links over single-mode fiber. It uses a 1310 nm wavelength and a metal housing, operates from a 3.3 V supply and weighs approximately 2 g. The module implements an LC duplex interface and conforms to MSA SFP+ form-factor expectations, offering compatibility with network platforms that accept 10GBASE-LR SFP+ transceivers.

Advantages

This SFP+ transceiver supports 10 000 Mbit/s data rates with a 1310 nm transmitter/receiver pair to enable long-reach single-mode connections. Its compact metal housing provides mechanical robustness and thermal conduction, while the low weight simplifies handling and installation. The module supports standard SFP+ interfaces and is intended for straightforward integration into switches, routers and other 10G-capable equipment. Where supported by the host, digital diagnostic monitoring (DDM/DOM) can provide real-time operational parameters to assist in remote monitoring and troubleshooting.

Suitable for

• 10 Gbit/s Ethernet links over single-mode fiber
• Long-reach fiber connections between switches and routers
• Data center uplinks and aggregation ports
• Storage network connections and server interconnects

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm (transmitter and receiver)
• Connector: LC duplex
• Power supply: 3.3 V input
• Housing: metal
• Weight: approx. 0.002 kg

How to use

Install the transceiver into a compatible SFP+ slot on your network device until it seats firmly; avoid excessive force. Connect single-mode LC duplex fiber patch cords with correct transmit/receive orientation. Ensure the host device supports 10GBASE-LR SFP+ modules and, if required, enable or verify the digital diagnostic monitoring feature via the device management interface. Power-cycling the host is generally not necessary when inserting hot-pluggable SFP+ modules, but follow your hardware vendor’s insertion and removal procedures to avoid link disruption.

Usage recommendations

Use single-mode fiber and high-quality LC duplex patch cords to achieve specified reach and signal quality. Verify compatibility with the target hardware and confirm DDM/DOM support if remote diagnostics are needed. Handle the transceiver by its body, keep optical interfaces covered when not in use, and perform end-to-end testing after installation to validate link performance.