Fibre optic cable BlueOptics X66200-30-BO MPO OM3 30 m Aqua

The BlueOptics X66200-30-BO MPO OM3 30 m Aqua is a 30‑meter multimode fibre optic patch cable with MPO connectors on both ends, designed for high-density environments. It uses laser‑optimized OM3 fibre in an aqua LSZH sheath and supports full‑duplex optical links for high‑speed data transmission. The cable is suitable for interconnecting patch panels and optical transceivers in data centres and high‑performance computing infrastructures where reliable multimode MPO connectivity is required.

Advantages

This MPO MPO OM3 cable provides low attenuation and high return loss values typical of laser‑optimized multimode fibre, enabling efficient short‑reach transmission. The LSZH outer jacket minimizes smoke and excludes halogens in case of fire, meeting common safety requirements for installation in confined spaces. Connectors use zirconia ceramic ferrules for consistent mating and a rated lifecycle of up to 1500 mating cycles. Each cable is tested with interferometry and OTDR to verify input loss and return loss and is produced to comply with applicable industrial standards.

Подходит для

• Interconnection of patch panels in data centres
• Connecting MPO transceivers and breakout assemblies
• High‑density cabling trunks and cross‑connects
• Short‑reach 10G/40G/100G multimode links where OM3 is specified

Key specifications

• Fibre type: Multimode OM3 (laser‑optimized)
• Connector type: MPO to MPO, duplex/full‑fibre parallel configuration
• Length: 30 m
• Jacket: LSZH (low smoke zero halogen), aqua colour
• Attenuation: Low input loss and high return loss (factory tested)
• Ferrule material: Zirconia ceramic
• Testing: Interferometer and OTDR measurement with supplied protocol
• Standards compliance: Manufactured to common industry norms for fibre optic patch cables

How to use

Install the BlueOptics MPO OM3 cable by aligning the MPO connector keys with the corresponding ports on patch panels or transceiver modules, then seat the connector until it latches. Use the full 30 m length to route between racks or cross‑connect frames as required, avoiding tight bends and maintaining the minimum bend radius. Verify link performance after installation by checking the supplied input loss and return loss values or by running an optical link test with appropriate equipment.

Usage recommendations

For best results, handle the MPO connectors with protective caps until use, avoid exposure to dust, and secure the cable to prevent strain on the connectors. Use this OM3 MPO cable for short‑reach multimode applications such as 10G/40G/100G where OM3 performance is acceptable; for longer multimode reaches consider OM4 or singlemode alternatives. Keep bend radius above the manufacturer’s minimum and follow local fire‑safety installation codes when routing the LSZH cable.