Fiber Optic 10G Transceiver CBO XFP-5901 — XFP module for 10 Gigabit links

CBO XFP-5901 is a fiber optic 10G XFP transceiver module designed for 10 Gigabit Ethernet and other compatible optical interfaces. The module uses a hot-pluggable XFP form factor to allow easy insertion and removal in network equipment that supports XFP ports. It provides a single high-speed optical link for reliable 10G data transmission over multimode or single-mode fiber depending on the specific variant and is intended for use in data centres, carrier networks and enterprise campus backbones where standardized 10 Gigabit connectivity is required.

Advantages

The XFP form factor supports hot-swap installation, reducing maintenance windows and enabling quick upgrades. The transceiver is built to industry-standard electrical and optical interfaces, ensuring interoperability with a wide range of switches, routers and server line cards that accept XFP modules. Its design focuses on stable 10G performance, predictable optical budget and low-latency transmission suitable for high-throughput networking scenarios.

Suitable for

• 10 Gigabit Ethernet uplinks in switches and routers
• Data centre interconnects and server-to-switch links
• Carrier and ISP backbone links
• Enterprise backbone and aggregation layers

Key specifications

• Form factor: XFP hot-pluggable transceiver
• Data rate: 10 Gbps
• Optical interface: single optical channel (depends on fiber type and wavelength variant)
• Compatible with standard 10G Ethernet physical layer requirements
• Operating temperature range suitable for typical network equipment racks
• Power consumption within typical XFP module class limits

How to use

Insert the module into an available XFP slot on a compatible switch, router or server line card while the host device is powered according to the equipment vendor’s hot-swap guidelines. After insertion, connect the appropriate optical fiber patch cord to the transceiver’s optical interface and ensure correct fiber type and polarity. Verify link status using the host device’s management interface and monitor optical levels and alarms as provided by the equipment.

Usage recommendations

Use factory-tested fiber patch cords of the correct type (single-mode or multimode) and maintain clean fiber connectors to preserve signal integrity. Confirm compatibility with the host device’s XFP slot and firmware requirements before deployment, and follow ESD precautions when handling the module.