Drip Tape BRADAS 16mm HIRRO TAPE 500m, wall 16/8 mil, flow 1.5 l/h, spacing 10 cm

Flexible drip tape BRADAS HIRRO TAPE 16mm, 500 m roll, is designed for low-pressure micro-irrigation of vegetable beds, greenhouses, orchards and container crops. The tape has a nominal width of 16 mm and wall construction specified as 16/8 mil. Integrated emitters are spaced at 10 cm and provide a flow rate of 1.5 l/h, delivering uniform water distribution along the line while reducing surface evaporation and runoff.

Advantages

BRADAS HIRRO TAPE combines a narrow profile with regular emitter spacing to ensure even moisture delivery across planting rows. The integrated emitters with a flow of 1.5 l/h support efficient water use at low operating pressures. The 500 m roll length minimizes the number of joins required on larger installations and simplifies layout planning. The material and wall specification provide resistance to deformation under typical field pressures and allow for easy handling during installation and maintenance.

Suitable for

• Drip irrigation of vegetable beds and row crops
• Greenhouse bench and tunnel irrigation
• Orchard under-tree irrigation and young orchard establishment
• Potted plants and container nursery irrigation

Key specifications

• Nominal width: 16 mm
• Roll length: 500 m
• Wall construction: 16/8 mil
• Emitter spacing: 10 cm
• Emitter flow rate: 1.5 l/h
• Low-pressure micro-irrigation type

How to use

Lay the drip tape along planting rows or benches, ensuring the tape follows the crop line and emitters face toward the root zone. Connect the tape to a filtered water supply and pressure regulator appropriate for low-pressure systems. Secure the tape at intervals to prevent movement and check for uniform wetting after system start-up. Perform routine inspection for blockages and damage and flush the line periodically according to water quality and local maintenance practices.

Usage recommendations

Use a particulate filter and, if necessary, chemical or physical filtration suitable for your water source to reduce emitter clogging. Maintain operating pressure within the range recommended for low-pressure drip tape systems and avoid sharp bends or tensile strain during installation to prolong service life.