C2G OM4 2 m LC to LC Fibre Optic Patch Cable - Purple, Duplex 50/125 µm LSZH

The C2G OM4 2 m LC to LC Fibre Optic Patch Cable is a high-performance networking solution designed for reliable, high-speed data transmission in modern network environments. Featuring a vibrant purple color for easy identification, this duplex 50/125 µm multimode fibre optic patch cable ensures optimal signal integrity for demanding applications. Equipped with precision LC connectors on both ends, it is engineered to meet the rigorous demands of contemporary data centres, enterprise networks, and telecommunication rooms. The cable is constructed with a low smoke zero halogen jacket, prioritizing safety by minimizing the emission of toxic and corrosive gases in the event of a fire.

Advantages

This fibre optic cable delivers exceptional performance headroom, supporting high-speed 40 Gigabit and 100 Gigabit Ethernet communication standards without signal degradation. The OM4 specification ensures reliable connectivity for advanced network equipment, including 40GBase-SR4 and 100GBase-SR10 transceivers, as well as SFP+ and QSFP+ modules. Its backward compatibility with existing 50/125 equipment allows for seamless integration into current network infrastructures while preparing systems for future upgrades. Additionally, the low smoke zero halogen jacket provides enhanced safety compliance for indoor installations, reducing hazards in enclosed spaces.

Suitable for

• Connecting 40G and 100G network hardware in data centres
• Linking SFP+ and QSFP+ transceivers in enterprise switch setups
• High-density telecommunication room and wiring closet patching
• Upgrading existing multimode fibre infrastructures to support higher bandwidth

When it may not be suitable

This cable is not designed for single-mode network architectures or long-distance outdoor runs requiring armored cabling. It may also be unnecessary for basic legacy networks operating below Gigabit speeds where standard Cat6 copper or older OM1/OM2 fibre cables are already sufficient.

Key specifications

• Cable length: 2 metres
• Fibre optic type: OM4 multimode
• Core and cladding diameter: 50/125 micrometres
• Connector 1: LC male
• Connector 2: LC male
• Operation mode: Full duplex
• Data transfer rate: Up to 100 Gbit/s
• Jacket material: Low smoke zero halogen (LSZH)
• Colour: Purple

How to use

Before installation, inspect the LC connectors for any dust or debris and clean them using appropriate optical fibre cleaning tools if necessary. Gently remove the protective dust caps from both ends of the patch cable. Align the LC connector with the port on your network device, transceiver, or patch panel, and push straight in until an audible click confirms that the latch is secure. Route the cable carefully through cable management channels, avoiding sharp bends or excessive tension that could exceed the minimum bend radius of the fibre strand. To disconnect, press the release tab on the LC connector and pull straight out without twisting.

What to consider before purchase

• Verify the correct connector type matches your hardware ports
• Measure the required cable distance to ensure the 2-metre length is adequate
• Confirm your network transceivers support OM4 multimode fibre specifications
• Check local building safety codes regarding the requirement for low smoke zero halogen jackets

Always maintain proper cable management practices and avoid exceeding the recommended bend radius to ensure long-term signal integrity and prevent physical damage to the fibre optic strands.