Garden irrigation technical hose Cellfast T10 8.0×2.5 mm, 80 m

Cellfast T10 technical hose 8.0×2.5 mm, 80 m is a flexible supply line intended for garden irrigation and outdoor water delivery. With an inner diameter of 8.0 mm and a wall thickness of 2.5 mm across an 80‑metre length, this hose is designed to form continuous runs for sprinklers, drip systems and manual watering. Constructed for outdoor use, it provides a practical solution where a long, uninterrupted conduit is required to carry water from a source to irrigation points.

Advantages

The hose combines a narrow internal diameter with a robust wall to maintain water flow and withstand normal outdoor stresses. Its 80 m length reduces the need for joins or frequent couplings, simplifying installation of long irrigation layouts. Lightweight flexibility allows it to be routed along beds and around obstacles while retaining sufficient rigidity to avoid kinking in typical garden conditions.

Suitable for

• Continuous runs to supply garden sprinklers and pop‑up heads
• Feeding dripline manifolds and inline drippers over long distances
• Temporary or semi‑permanent water supply for allotments and small fields
• Manual watering with inline fittings and shut‑off taps

Key specifications

• Inner diameter: 8.0 mm
• Wall thickness: 2.5 mm
• Length: 80 m
• Application: outdoor garden irrigation and water delivery
• Flexible construction suitable for routing along beds and under light cover

How to use

Cut the hose to the required lengths with a sharp knife or hose cutter, ensuring clean, square ends before attaching fittings. Use compatible irrigation connectors, barbed couplings or clamps sized for an 8.0 mm inner diameter. Position the hose along the desired run and secure it with stakes or clips where needed to prevent displacement. Connect the supply end to a tap, pump or manifold and test the system at low pressure to check for leaks, then increase to operating pressure within the recommendations of the irrigation components you use.

Usage recommendations

For long‑term outdoor installations, avoid prolonged exposure to direct sunlight without shading where possible and drain the hose before freezing conditions. Use corrosion‑resistant clamps and compatible fittings to maintain seal integrity. When routing through sharp bends, support the hose to reduce strain and minimize the risk of deformation.