Leave your address - as soon as the price of the product goes down, you'll know about it right away
Hose connector angled 300 mm CERSANIT for SYSTEM AQUA 5/7/9 (K99-0258)
Hose connector angled 300 mm CERSANIT for SYSTEM AQUA 5/7/9 (K99-0258)
In cart {{totalProductsCount}} item(s)
Your cart is empty
Hose connector angled 300 mm CERSANIT for SYSTEM AQUA 5/7/9 (K99-0258)
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Hose connector angled 300 mm CERSANIT for SYSTEM AQUA 5/7/9 (K99-0258)
Hose connector angled 300 mm CERSANIT for SYSTEM AQUA 5/7/9 (K99-0258)
The CERSANIT angled hose connector 300 mm for SYSTEM AQUA 5/7/9 is a plumbing fitting designed to provide a compact 90-degree water connection in installations using the specified SYSTEM AQUA series. It serves as an intermediary between supply lines and fixtures or components where an angled inlet is needed, offering a 300 mm projection to position the connection point away from the wall or mounting plane while maintaining alignment with SYSTEM AQUA 5/7/9 interfaces.
This angled hose connector delivers a standardized ninety-degree orientation with a fixed 300 mm length, enabling straightforward alignment in tight or recessed installation locations. The design facilitates a neat transition between horizontal and vertical runs, reduces the need for additional elbows or adapters, and supports clean routing of water supply hoses compatible with the SYSTEM AQUA family. Material selection and dimensional conformity aim to ensure leak-resistant joints when installed according to recommended practices.
Install the connector by aligning the angled end with the SYSTEM AQUA 5/7/9 interface and securing the hose connection according to the system's assembly instructions. Ensure sealing elements (such as O-rings or thread tape) specified by the installation guide are in place to prevent leaks. Tighten connections to the torque or hand-tightening recommendations provided for SYSTEM AQUA fittings, and verify correct orientation so the 300 mm projection positions the hose as required for the fixture layout.
Before installation, confirm compatibility with your specific SYSTEM AQUA model and inspect sealing surfaces for damage. Use appropriate sealing materials and avoid over-tightening. After installation, perform a pressure/leak test according to local plumbing codes and the SYSTEM AQUA instructions.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}