Wired 6-zone 24V floor heating control module Comap C412004001

The Comap Wired 6-zone 24V floor heating control module C412004001 is a centralized control unit designed for underfloor heating systems that require zoned management. Operating at 24V, this module handles up to six independent heating circuits and is intended to interface with room thermostats, actuators or motorized valves on manifolds. It provides a compact and organized solution for coordinating multiple zones in residential and light commercial installations where reliable, low-voltage control is needed.

Advantages

This wired 6-zone module offers straightforward wiring and installation for multi-zone underfloor heating systems and ensures low-voltage operation for safety and compatibility with common thermostats and actuators. The unit centralizes switching for up to six circuits, simplifying system layout and allowing clear separation of heating zones. Its design supports integration with room-level controls and building automation systems, enabling accurate zone-by-zone temperature regulation and reduced energy waste compared with single-zone setups.

Suitable for

• Residential underfloor heating systems with multiple rooms or zones
• Light commercial buildings requiring zoned floor heating control
• Installations using motorized actuators or valves on heating manifolds
• Systems that integrate with room thermostats or building control systems

Key specifications

• Number of controlled zones: 6 independent circuits
• Control voltage: 24 V DC supply for thermostats and actuators
• Connection type: wired inputs and outputs for thermostats and actuator drives
• Mounting: panel or DIN-rail compatible compact enclosure for utility cabinets
• Compatibility: designed to work with standard room thermostats and 24V motorized actuators used in underfloor heating manifolds

How to use

Install the module in a suitable electrical enclosure following local electrical regulations and manufacturer mounting guidelines. Connect the 24V supply and wire each zone output to the corresponding actuator or valve on the manifold. Connect room thermostats or a central control bus to the module inputs according to the thermostat wiring diagram; verify polarity and terminal assignments before energizing. After wiring, power up the system and confirm each zone responds to its thermostat by observing actuator movement or valve position. Commission each zone, adjust setpoints at the thermostats, and verify proper cycle times and sequencing to avoid short-cycling.

Usage recommendations

Use matching 24V thermostats and actuators to ensure reliable operation and to maintain system safety. Keep wiring runs organized and protected, and label zone connections for easier maintenance. In mixed systems or larger installations, coordinate the control module with hydraulic balancing and pump control to optimize comfort and energy efficiency.