DEDRA DED70571 air compressor accessory 1 pc(s)

Replacement spray nozzle with a 2.0 mm orifice designed for use with the Dedra DED7057 paint sprayer. This spare part restores the original spray pattern and flow characteristics to the sprayer, enabling consistent application of paints, enamels and water- or solvent-based coatings. Constructed to fit the manufacturer's nozzle housing, the nozzle is intended for routine maintenance and repair to maintain spraying performance on interior and exterior surfaces.

Advantages

The 2.0 mm spray nozzle provides a balanced atomization and flow rate suitable for medium-viscosity paints, improving coverage uniformity and reducing runs when used under recommended conditions. As a direct-fit replacement, it simplifies maintenance and reduces downtime by restoring the sprayer's intended spray geometry. The nozzle's orifice size supports controlled material consumption and predictable spray fan width for repeatable results.

Suitable for

• Touch-up and maintenance of Dedra DED7057 paint sprayer
• Applying latex, acrylic and solvent-based paints with medium viscosity
• Interior walls, ceilings and furniture refinishing
• Exterior surfaces requiring even coat application

Key specifications

• Orifice diameter: 2.0 mm
• Compatible spray pattern for medium-width fan
• Material: corrosion-resistant metal suitable for paint contact
• Intended use: replacement/repair for spray performance restoration

How to use

Before replacing the nozzle, ensure the sprayer is switched off and depressurized according to the manufacturer's safety instructions. Remove the existing nozzle from the nozzle housing following the device manual, clean the surrounding area to remove paint residues and debris, then install the 2.0 mm nozzle by seating it firmly in the housing and securing any retaining parts. After installation, perform a test spray on a disposable surface to verify spray pattern and adjust pressure or tip distance as needed for the selected coating.

Usage recommendations

Use the 2.0 mm nozzle with paints and coatings within the manufacturer's recommended viscosity range. Filter paints to remove lumps, thin if required and always conduct a short test spray to confirm atomization and coverage before proceeding with large surfaces.